Da-Lite Contour Electrol Gebrauchsanweisung - Seite 2
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektionsfläche Da-Lite Contour Electrol herunter. Da-Lite Contour Electrol 13 Seiten. Installer friendly features
Auch für Da-Lite Contour Electrol: Gebrauchsanweisung (9 seiten), Handbuch für Installateure (2 seiten), Gebrauchsanweisung (4 seiten), Gebrauchsanweisung (8 seiten), Gebrauchsanweisung (8 seiten)
Seite drucken
IMPORTANT SAFETY INSTRUCTIONS
When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over,
pulled, or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current
rating at least equal to that of the appliance should be
used. Cords rated for less amperage than the appliance
may overheat.
TOOLS REqUIREd FOR INSTALLATION
#2 Phillips Screwdriver
PRE-INSTALLATION
1. Carefully unpack screen and remove outer wrapping
from case.
INSTALLATION
NoTe: Remove the black tape and rubber bands from the slat
bar after the case has been installed.
There are three ways to install the Contour electrol — Wall
Mount, Ceiling Mount, or Ceiling Hook. Procedures for each
method are as follows:
Wall Mount
1. Using a #2 Phillips screwdriver, loosen the two stop
screws and remove the wall mount bracket from the back
side of the case (Figure 1).
NoTe: The ceiling flush mount and ceiling hook mount
brackets are attached to the top side of the case. These
brackets are not necessary for wall mounting and can be
removed at this time.
2. Secure the wall mount bracket to the wall at the desired
height. The wall mount bracket should be fastened to the
wall studs or some reinforcement within the wall. Concrete
or brick walls require special fasteners and anchors. Allow
at least 2-3/8" above the wall mount bracket to be able to
position the case on the bracket (Figure 2).
2
4. To reduce the risk of electric shock, do not disassemble
this appliance. Contact an authorized service dealer when
repair work is required. Incorrect reassembly can cause
electric shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended
by the manufacturer may cause a risk of fire, electric
shock, or injury to persons.
2. Set aside the Installation Kit. Items inside will be used during
installation.
5-11/16"
6-3/8"
2-5/16"
Case Hook
Wall Mount
Bracket
Stop Screws
Slat Bar
Figure 1
2-9/16"