American Standard Advanced Clean 3.0 SpaLet Installationshandbuch - Seite 15
Blättern Sie online oder laden Sie pdf Installationshandbuch für Toiletten American Standard Advanced Clean 3.0 SpaLet herunter. American Standard Advanced Clean 3.0 SpaLet 18 Seiten. Bidet seat
Seite drucken
6. Positioning and Mounting the Remote Control
● Remote control installation position
Install the remote control to a position where the
user can reach and operate it.
Install the remote control in the area shown as "Suggested
installation area" in the figure below, and ensure to install the
remote control on a position where it can be operated easily
while the user is seated on the SpaLet
900 mm (35-7/16")
600 mm (23-5/8")
1. Installing the Batteries and Confirming the Remote Control Installation Position
1. Open the back cover of the remote control, and
install the included batteries (AA x 2).
* Use a tool such as a flat-blade screwdriver to push the
hook (lock) to remove the cover.
2. Confirm the remote control installation position.
2. Mounting the Remote Control
1. Remove the holder from the remote control.
2. Install the holder to the installation
position using an appropriate method for
the wall.
[See Note 7-2]
* Out of 4 slots, use the outer 2 slots (with A
marks). If the holder can
be installed only with a
hole pitch at 100 mm (3-
15/16"), use the inner 2
slots.
[For a plywood wall (> 5 mm (3/16") thick)]
Affix the holder firmly with the supplied wood
screws.
[For a plywood wall (<5 mm (3/16") thick)
or a plaster board wall]
Make the pilot holes with 6 mm (1/4") diameter.
(5 mm (3/16")
diameter for a plaster
board wall)
Use a hammer to
insert the supplied
plastic anchors gently.
Affix the holder firmly
with the wood screws.
®
seat.
Suggested installation area
Installation Procedure
[See Note 7-1]
Holder
Wood
screws
Φ 6 mm (1/4")
Plastic
anchors
Holder
Wood screws
-15 - EN-
● Sit on the SpaLet seat and ensure the installation
[See Note 7-1]
position.
Temporarily install the remote control to the target position, and
sit on the SpaLet seat unit and press the [Stop] button
(ensure to perform a test operation after installation).
Then, stand in front of the toilet bowl
and push the [Stop] button to ensure
that a beep sound is generated from
the SpaLet seat unit.
• Do not push the [Cleansing] or [Bidet]
button: water would come out from
the SpaLet seat unit.
• Ensure that there is enough space above the remote con-
trol installation position to allow easy removal and mount of
the remote control.
Hook (lock)
Batteries
The wood screws are tight at the beginning, and then
loosened once and tightened again.
[For a concrete wall]
Make the pilot holes
with 6 mm (1/4")
diameter and ap-
prox. 33 mm (1-5/16")
depth.
Use a hammer to
insert the supplied
plastic anchors gently.
Affix the holder firmly
with the wood screws.
3. Align the remote
control to the holder,
and push downward
to mount the remote
control.
Back cover
Remote control
33 mm
(1-5/16")
Plastic anchors
Φ 6 mm
(1/4")
Holder
Wood screws
Remote
Control
Holder