American Standard CADET 3 FloWise 2832.128 Montageanleitung Pflege und Wartung - Seite 2

Blättern Sie online oder laden Sie pdf Montageanleitung Pflege und Wartung für Toiletten American Standard CADET 3 FloWise 2832.128 herunter. American Standard CADET 3 FloWise 2832.128 4 Seiten. Two-piece toilet

Seite drucken

BOLT CAP

WASHER

NUT

INSTALL TOILET

a. Position toilet squarely to wall and, with a rocking

motion, press bowl down fully on wax ring and flange.

Alternately tighten nuts until toilet is firmly seated on floor.

DO NOT OVERTIGHTEN NUTS

OR BASE MAY BE DAMAGED!

b. Install caps on washers. (If necessary, cut bolt height

to size before installing caps.)

c. Smooth off the bead of sealant around base.

Remove excess sealant.

INSTALL TOILET SEAT Install toilet seat in accordance with manufacturer's directions.

Before continuing, determine the type of water supply connecation you have from

the chart below and use the appropriate assembly parts required to properly

reconnect the water supply. DO NOT use plumber's putty to seal these fittings.

METAL / COPPER

METAL FLANGED

FLARED TUBING

TUBING

LOCK NUT

CONE

WASHER

COUPLING

NUT

WATER

SHUT-OFF

These parts must be used as

illustrated to insure water-tight

connection. Use of existing

coupling nut may result in

water leakage. Water supply

tube or pipe must extend at

least 1/2" inside threaded

shank of valve (does not

apply to flanged tubing).

CAUTION: DO NOT USE

CONE WASHER WITH

PLASTIC SUPPLY LINE.

WARNING: Do not use plumber's putty, pipe dope, or any other sealant on the water supply connection to this tank. If the connection

leaks after hand tightening, replace the supply line. If the connection continues to leak with the new supply line, replace the fill valve.

Warranty is void if any type of sealant is used on the water supply connection.

CLOSET FLANGE

CLOSET BOLT

CAUTION:

METAL SPIRAL

TUBING

LOCK NUT

EXISTING

WASHER

CONE

WASHER

EXISTING

COUPLING

NUT

WATER

SHUT-OFF

Use existing

Use existing spiral

coupling nut

cone washer.

and washer.

Fluidmaster cone

washer may not

seal completely on

spiral type supply

line.

CAUTION: Overtightening of

LOCK NUT or COUPLING NUT

could result in breakage and

potential flooding.

For Tanks/Bowls using Speed Connect System

(Tank mounting bolts pre-installed).

TANK MTG.

BOLTS PRE-

INSTALLED

WASHER/

COMBO

INSTALL TANK

a. Install large rubber gasket over threaded

outlet on bottom of tank and lower tank

onto bowl so that tapered end of gasket

fits evenly into bowl water inlet opening,

and tank mounting bolts go through

mounting holes. Secure with metal

washer/nut combo.

b. With tank parallel to wall, alternately

tighten nuts until tank is snugged down

evenly against bowl surface.

USE INCLUDED TOOL, NUT DRIVER, OR DEEP SOCKET RACHET.

DO NOT OVERTIGHTEN NUTS MORE

THAN REQUIRED FOR A SNUG FIT!

VINYL / BRAIDED

CONNECTOR

LOCK NUT

COUPLING

NUT

WATER

SHUT-OFF

Captive cone

washers already

included. No

additional washers

needed.

- 2 -

RUBBER

GASKET

NUT

CAUTION:

With correct washers in

place (see Step 9a),

tighten COUPLING NUT

1/4 turn beyond hand tight.

DO NOT OVERTIGHTEN.

7 30 9 2 8 - 10 0 Rev. Q