Da-Lite Polacoat Da-Plex Semi-Rigid Gebrauchsanweisung - Seite 3
Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektionsfläche Da-Lite Polacoat Da-Plex Semi-Rigid herunter. Da-Lite Polacoat Da-Plex Semi-Rigid 12 Seiten.
Seite drucken
Included Hardware
NOTE: Quantities listed are for standard sizes. Quantities will vary if a custom screen that is larger than standard is ordered.
(1) Screen Surface
(4) pairs – Gloves
(3) 30' Ropes
(2) 4" Pieces of Trim
(3) Lifting Brackets
(4) Cap Screws
(24) Tensioning Assemblies
(2) Hoisting Brackets
(6) T-Tracks
(6) Frame Pieces
(4) Rubber Gaskets
(4) Trim Pieces
Maintenance and Protection
Projection screens should always be installed after the completion of construction, drywall, and painting of all adjacent areas. If
construction work needs to occur near an installed screen, clean polyethylene sheeting should be used to cover and protect both
surfaces. Never apply adhesive tapes to the coated surface. Always be careful to guard the screen against damage from moving
scaffolding, ladders, or staging materials.
General Cleaning
Never use solvents on or near Da-Lite rear projection screens. Remove dust by gently blotting the screen with a soft, clean, lint-free
cloth.
Dry Soil Marks
Clean with VM&P Naptha or with Da-Lite Lenskleen and a soft, clean, lint-free cloth.
Cleaning of Frame and Trim
The exposed surfaces of the aluminum frames can be cleaned with a dilute solution of detergent and water, followed by a clear water
rinse. Use a soft, grit-free cloth to preserve the anodized finish. Protect screen surface during frame cleaning. Do not use abrasive
cleaners or solvents.
3