Da-Lite Multi Format Imager Gebrauchsanweisung - Seite 3

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Projektor-Zubehör Da-Lite Multi Format Imager herunter. Da-Lite Multi Format Imager 12 Seiten.
Auch für Da-Lite Multi Format Imager: Gebrauchsanweisung (20 seiten)

Seite drucken

Unpackaging the Frame:

The frame will arrive in two separate cardboard boxes. One

box will be very long and will house the top & bottom pieces.

The smaller cardboard box will house the side frame pieces,

hanger hardware, hardware required to put frame together

and the wall switch.

2. To open the boxes there is a side flap that is taped down the

length of the box. It will be labeled OPEN THIS SIDE (Figure 1).

Carefully cut tape down the length of the box with a utility

knife and fold box open. You will have to tear hard on the

ends as it is stapled on the ends.

Frame Assembly

In the hardware bag, you will receive (12) #10 x .375" long hex

button head screws and (4) #10 x .500" long hex button head

screws required for frame assembly.

2. Lay frame pieces out on floor or table as shown in Figure 1.

The top frame assembly has the roller and motor assembly

attached to it. The side frames are the two shorter pieces.

Watch side piece to make sure oriented properly. The sides

have two riv nuts used for roller mounting brackets that

should face toward the top frame piece.

Rivnut

Top of Frame

Left of

Frame

Bottom of Frame

3. Inside each box the frame pieces will be individually paper

wrapped and taped. Remove all paper from pieces.

CAUTION: DO NOT USE A UTILITY KNIFE TO REMOVE

PAPER FROM PIECES

ATTENTION: N'UTILISEZ PAS DE COUTEAU UTILITAIRE

POUR RETIRER LE PAPIER DES PIÈCES.

4. Remove all paper and styrofoam blocks from top frame

assembly after unwrapping.

Right of

Frame

Figure 1

Make sure slat is

guided in to the

channel