American Standard Lexington 718AA Einbauanleitung - Seite 3
Blättern Sie online oder laden Sie pdf Einbauanleitung für Toiletten American Standard Lexington 718AA herunter. American Standard Lexington 718AA 4 Seiten. Two-piece toilet
Seite drucken
10
FILL
VALVE
VALVE
BODY
ADJUSTABLE
HEIGHT
LOCK NUT
CONE WASHER
COUPLING NUT
(HAND TIGHT ONLY)
ADJUSTMENTS
a.
Adjust water level. Water level should be adjusted to level indicated on tank by
adjusting float cup.
See Step 11 for water level adjustment method
b.
If bowl fails to siphon, an adjustment may be required with the lift chain. Simply
remove the bead chain from the retainment clip (see Fig. 10) and take up
slack on the chain, and reinsert on lift rod. Make sure the chain is not too taught.
12
CARE AND CLEANING
When cleaning your toilet, wash it with mild, soapy water, rinse thoroughly with clear water and dry with a soft cloth. Avoid detergents,
disinfectants, or cleaning products in aerosol cans. NEVER use abrasive scouring powders or abrasive pads on your toilet seat. Some
bathroom chemicals and cosmetics may damage the seat's finish.
WARNING:
!
Do not use in-tank cleaners. Products containing chlorine (calcium hypochlorite) can seriously damage fittings in the
tank. This damage can cause leakage and property damage.
American Standard shall not be responsible or liable for any tank fitting damage caused by the use of cleaners containing
chlorine (calcium hypochlorite).
PROBLEM
POSSIBLE CAUSE
Does not flush
a. Water supply valve closed.
b. Supply line blocked.
c. Flush valve chain too loose or disconnected.
Poor or sluggish flush
a. Bowl water level too low.
b. Supply valve partly closed.
c. Partially clogged trapway and/or drain pipe and/or vent.
d. Supply pressure too low.
Toilet leaks
a. Poor supply line connection.
b. Poor bowl to tank/floor connection.
Toilet does not shut off
a. Flush valve chain too tight, holding flush valve open.
b. Flush valve seat and/or flapper worn or deformed.
REFILL
TOP
TUBE
FLOAT
CUP
FLAPPER
SHANK
WASHER
THREADED
SHANK
PARTS FOR WATER
CONNECTION
TROUBLESHOOTING GUIDE
11
FLUSH
VALVE
CORRECTIVE ACTION
a. Open valve and allow water to fill tank.
b. Shut off water supply, disconnect supply line, and inspect
all gaskets and washers.
c. Readjust chain length as required.
a. Check that refill tube is connected to water control and
inserted into tank overflow without being kinked or damaged.
b. Open supply valve fully. Be sure that proper supply tube size is used.
c. Remove obstruction. Consult a plumber if necessary.
d. Normal supply pressure must be at least 20 psi.
a. Review Step 9 of installation procedure.
b. Review Step 4 through 7 of installation procedure.
a. Readjust chain length as needed. Review step 10.
b. Replace flapper/flush valve assembly, as needed.
- 3 -
Filter Screen
Adjust tank water level to the proper marked
waterline by rotating threaded rod clockwise
to raise water level or counterclockwise to
lower water level.
7302076-100 Rev. B 5 / 18
Remove tape
before flushing.