Donaldson Torit TBI 5 Installations- und Betriebshandbuch - Seite 14
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Fan Donaldson Torit TBI 5 herunter. Donaldson Torit TBI 5 20 Seiten. Backward inclined fan
Seite drucken
Donaldson Company, Inc.
Maintenance Information
Instruct all personnel on safe use and maintenance
procedures.
Use proper equipment and adopt
all safety precautions needed
for servicing equipment.
Electrical service or maintenance work must
be performed by a qualified electrician and
comply with all applicable national and local
codes.
Turn power off and lock out electrical
power sources before performing service or
maintenance work.
Do not install in classified hazardous
atmospheres without an enclosure rated for
the application.
When mounting fan in an
outdoor or high humidity
environment, mount the motor with drain holes
facing down to extend motor life.
For additional information, contact the motor
manufacturer.
Donaldson Torit TBI fans are manufactured to high
standards with quality materials and components. Proper
maintenance will ensure a long and trouble-free service
life.
11
The key to good fan maintenance is regular and
systematic inspection of all fan parts. Inspection
frequency is determined by the severity of the application
and local conditions. Strict adherence to an inspection
schedule is essential.
Wheel to Drive Side Plate Clearances
Regular fan maintenance should
include the following:
Check the fan wheel for any wear or corrosion,
as either can cause catastrophic failures.
Check also for the build-up of material which
could cause unbalance resulting in vibration,
bearing wear and serious safety hazards. Clean
or replace the wheel as required.
Lubricate the bearings, but do not over
lubricate.
Periodically inspect the shaft for dirt buildup,
corrosion and signs of excess stress or fatigue.
During any routine maintenance, all setscrews
and bolts should be checked for tightness. See
Torque Value Table.
When installing a new wheel or cone, the
proper wheel-to-drive side plate must be
maintained as shown in Side Plate Clearance
Table. Inlet cone clearance should be uniform
around the circumference.
inlet cone
clearance
A