DAB ACTIVE J112 Anleitung für Installation und Wartung - Seite 8
Blättern Sie online oder laden Sie pdf Anleitung für Installation und Wartung für Water Pump DAB ACTIVE J112 herunter. DAB ACTIVE J112 20 Seiten.
4.4 Stopping the pump
The pump has a built-in electronic protection function
which allows it to stop in the event of:
− dry running,
− overheating,
− motor overload,
− blockage of the pump / motor.
After stopping in this way, the pump restarts
automatically, making 3 attempts of 3 minutes each,
with pauses of 10 seconds.
The starting attempts will be repeated, in the event of
a negative result:
− after 1 hour :
1 attempt of 3 minutes,
− after 4 hours :
1 attempt of 3 minutes,
− every 15 hours : 1 attempt of 3 minutes.
To perform manual resetting of the pump you must
supply power to it again, disconnecting the voltage for
a few seconds.
5. INSTALLATION AND CONNECTION
5.1 Pump installation
− The electropump must be installed in a well
ventilated place, protected from inclement weather
and with an environment temperature no higher
than 40°C.
− A solid anchoring of the pump to its support base
helps absorb any vibrations created by pump
operation.
− Always fit the pump on a base with the intake
opening horizontal and the delivery opening
vertical.
− The pump must be installed exclusively in
horizontal position (Fig.3):
Fig. 3
ENGLISH
To avoid transmitting vibrations to the system, after
−
delivery it is recommended to use the flexible pipe
that is supplied inside the packing. (Fig.4).
Fig. 4
− Do not allow the metal pipes to weigh down on the
pump openings, transmitting excessive strain, so as
not to create deformations or breakages. Anchor the
pipes separately if possible.
− The suction pipe must be as short as possible. For
suction depths of more than 4 metres or with long
horizontal stretches, it is recommended to use a
suction pipe with a diameter larger than that of the
suction opening of the electropump.
− To avoid the formation of air pockets in the suction
pipe, ensure a slight positive tilt of the same towards
the electropump.
− If it is not possible to use the flexible pipe to make
the connection, use only Teflon tape. (Fig.5).
− For any maintenance jobs it is recommended:
•
to fit an interception valve along the pipe, close
to the pump (Fig.6),
•
to use a straight length of pipe, after delivery, for
lifting the cover of the Active system, in the event
of inspection (Fig.6).
Fig. 6
22
Fig. 5