Dongcheng DJG04-355B Betriebsanleitung Handbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebsanleitung Handbuch für Trennschleifmaschinen Dongcheng DJG04-355B herunter. Dongcheng DJG04-355B 9 Seiten. Electric cut-off machine

Seite drucken

INSTRUCTIONS FOR OPERATION

Stop Screw

Stop screw is used to prevent cut-off wheel

from contacting with worktable or ground.

When installing the cut-off wheel, set the

stop screw at a higher position. When the

wheel is worn to less than 330 mm in

diameter, set the stopper at lower position

so that the servicing life of the machine can

be prolonged. (Fig. 1)

Installing

Removing

Wheel

Caution:



Always be sure that the machine is

switched OFF and unplugged before

installing or removing the cut-off

wheel.



Be sure to tighten the hex bolt

securely.



Always pull out the lock pin after

installing or removing the wheel or

before switching on the machine.

To remove the wheel, uplift the connecting

rod first (Fig. 2) and lift the adjustable guard

up to the end. (Fig. 3) Loosen the wing bolt

and pull the wheel guard cover backwards.

(Fig. 4)

Press the lock pin to prevent the wheel from

rotating. Loosen the hex bolt with wrench

the

-7-

and remove the hex bolt, outer flange and the wheel. (Fig. 5) Do not remove the O ring,

piston ring and the inner flange. (Fig. 6)

To install the wheel, follow the removing procedures in reverse.

Interval between Vise Plate and Guide Plate

The original spacing or interval between the vise plate and the guide plate is 0-170mm.

If your work requires wider spacing or

interval, proceed as follows to change the

spacing or interval.

Remove the two hex bolts which secure the

guide plate. Move the guide plate as the

direction of arrow shown in the right figure

and secure it by tightening the two hex bolts.

Then the space or interval can be set

between 35 to 205 mm or between 70 to 240

mm. But under such circumstance, fixity of

the workpiece turns bad relatively. (Fig. 7)

Setting

for

Desired

Cutting

Angle

Caution:

When the space or interval is set between

35 to 205 mm or between 70 to 240 mm, the

-8-