Astonica 50100039 Gebrauchsanweisung - Seite 2

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Inneneinrichtung Astonica 50100039 herunter. Astonica 50100039 2 Seiten. 3-piece aluminum bistro set

Seite drucken
PARTS & HARDWARE LIST
PART #
A
Table Top
B
Table Leg
C
Center Ring
D
Chair Back
Chair Seat
E
F
Chair Leg
G
Stud, 8mm x 30
H
Stud, 8mm x 25
I
Flat Washer, 8mm
J
Hex Nut, 8mm
K
Flat Washer, 8mm
L
Hex Nut, 8mm
M
Screw, 8mm x 30
A
D
G
H
I
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
DESCRIPTION
QUANTITY
B
C
F
E
J
K
L
1
Table Assembly
3
1. (SEE FIGURE 1) Place table top (A) upside
1
down on a flat non-scratch surface.
2
2. Thread studs (G) into three holes in
2
bottom of table top (A) until seated.
8
3. Attach table legs (B) to table top studs (G),
7
using flat washers (I) and hex nuts (J).
16
Do not fully tighten fasteners.
23
23
3
3
3
4. (SEE FIGURE 2) Position center ring (C) on
top of mounting tabs in legs (B).
5. Thread screw (M) through center ring (C),
and mounting tabs in legs (B).
6. Fasten center ring using flat washers (K)
and hex nuts (L).
7. Turn table upright on a flat level surface
and tighten all fasteners.
CAUTION: Do not over tighten fasteners.
CHAIR ASSEMBLY
(SEE FIGURE 3)
1.
holes in bottom of chair back (D).
M
2. Thread studs (H) in chairs seats (E)
until seated. Do not over tighten.
3. Place chair backs (D) on studs in chair
seats (E) and secure using flat washers (I)
and hex nuts (J).
4. Fit one chair leg (F) over studs in bottom of
chair seat (E).
5. Fasten chair leg to seat using flat
washers (I) and hex nuts (J).
6. Repeat for remaining legs.
ASSEMBLY INSTRUCTIONS
Figure 1
B
J
I
G
A
Figure 2
B
M
Figure 3
Thread studs (G) into
E
J
B
B
J
I
J
I
G
G
C
L
K
M
D
G
I
H
J
I
F