Donovan Hammer II Benutzerhandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Industrielle Ausrüstung Donovan Hammer II herunter. Donovan Hammer II 20 Seiten. Arm system for belly dumps, end dumps, dump bodies & pups

Seite drucken

P/N 1809533 Rev. B

Item Part #

Description

1809563 Bearing Plate - Universal

1809564 Bearing Plate Assembly

1809330 Tarp Spool Axle - 98"

1800980 Shaft Extension - 3/4" x 4"

1800089 Collar Shaft - 3/4"

1800758 Shaft Sprocket Assembly

C. 1703237 Cap Screw - 5/16" x 2-1/2"

H. 1800790 Cap Screw - 3/8" x 1-1/2"

1800990 Lock Nut - 5/16"

M. 1800993 Lock Nut - 3/8"

1800989 Flat Washer - 5/16"

Q. 1800994 Flat Washer - 3/8" GR5

STEP 1: Determine tarp axle bracket location on front of box.

Position brackets so spring-loaded arms will not

interfere with cab door, loader or exhaust stacks.

NOTE: If manual crank (page 30) will be installed on system

at any time, spacers or brackets may need to be fabricated to

align driver side tarp axle bracket with mounting surface for

manual crank.

STEP 2: Using bearing plate as guide, mark and drill 5/16"

holes into metal framework on box. Fasten plates

with screws

, washers

to sideboards only, fasten with 3/8" x 2 1/2" carriage

bolts, washers and nuts.

bearing plate

sideboard

bracket

NOTE: Install mounting plates directly across from each oth-

er, in line on opposite sides of box/cab guard.

and nuts

. If mounting

max or

windshield

may interfere

box

sideboard

STEP 3: Insert stub shaft into end of tarp axle with drilled hole

and fasten with screw

stub shaft

STEP 4: Measure distance between inside edges of bearing

plates. Measure and mark tarp axle 1" shorter than

this distance.

NOTE: Cut tarp axle

straight and square

for best results.

Front Drive - Side Plates

, washers

and nut

tarp axle

bearing

plate