AMERICH LUXURY Series Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Armaturen für das Badezimmer AMERICH LUXURY Series herunter. AMERICH LUXURY Series 4 Seiten.

Seite drucken

operating instructions

C O M B O S E R I E S + L I G H T

Always use dedicated outlets for each power supply.**

Blower On/Off

1st Press: The blower starts at 50%

2nd Press: The blower stops.

Blower System Speed

1st Press: Press and hold to increase the blower speed, release

pressure at the desired speed.

2nd Press: Press and hold to decrease the blower speed, release

pressure at the desired speed.

Blower Wave Mode

1st Press: Wave - Speed will vary gradually from maximum to

minimum.

2nd Press: Pulse - Speed will go directly to minimum and then

straight back to maximum.

3rd Press: Returns to maximum speed.

IMPORTANT: Keep these instructions with the Americh Installation Instructions. These operating instructions are for units with systems. All installation, warnings,

warranties, and other such information can be found in the Americh Installation Instructions. Go to www.americh.com for additional copies.

Manufacturer recommends the use of Jet Fresh ® or a similar system cleaning solution to maintain your whirlpool or Airbath® System.

Always check www.americh.com for the most updated installation instructions.

in compliance with

ANSI Z124.1 - 1995

ANSI A112.19.7 - 1987

ANSI A112.19.8 - 1987

City of Los Angeles

M980036 and M820132

Pump On/Off

Water Level Sensor

The system will turn OFF if the water level falls below the water level sensor

while pump is on.

If water falls below water level sensor while blower is on, an automatic purge

will initiate in thirty minutes to dry the air channels.

Automatic Purge

Thirty minutes after the water falls below the water level sensor the blower

will start again for a one-minute purge cycle allowing piping to thoroughly

dry.

Each system will automatically stop after 20 minutes.

**Note: Blower hose for AirBath Systems is shipped loose:

1) Remove red caps from blower and check valve.

2) Attached grey hose to blower and check valve.

3) Tighten clamp around each end.

l i s t e d b y

The pump starts

Chromotherapy

1st Press: Auxiliary equipment ON > White

2nd Press: Slow rainbow cycle

3rd Press: Fast rainbow cycle

4th Press: Turquoise, Blue, Magenta, Red, Orange, Yellow, Green

Return to slow rainbow cycle

Press and Hold 1 sec.: Auxiliary equipment OFF

The pump stops