AmeriGlide RUBEX Installationshandbuch - Seite 14

Blättern Sie online oder laden Sie pdf Installationshandbuch für Hebesysteme AmeriGlide RUBEX herunter. AmeriGlide RUBEX 16 Seiten.
Auch für AmeriGlide RUBEX: Benutzerhandbuch (8 seiten)

Seite drucken

INSTALLING THE UPPER LIMIT CAM

STEP 1: To install the upper limit cam, run the lift down about

1 foot by using the control on the armrest.

STEP 2: Locate the upper limit cam and move to the top of

the track - position it approximately ½" from top track cover

and tighten into place.

STEP 3: Final Limit Switch Actuator In the event that the

lift over travels or is moved up past the normal upper stop

position, the lift will push the final limit actuator up into the

final limit switch disabling the unit. In order to return the lift

to operation, you must manually hand crank the lift down the track a few inches, and then

slide the final limit actuator down approximately one inch by tapping on it.

INSTALLING THE CALL CONTROLS

Upper call control box

Lower call control box

Rubex Stair Lift Install Manual | www.Ameriglide.com | 866-378-6648

14 //

STEP 1: Finish routing the call control wire into the upper

track channel on the wall side of the track. Plug into one of

the two call control connectors.

STEP 2: Plug in the upper call control box to a call control

connector.

STEP 3: Plug in the lower call control box to the call

control connector at the bottom of the track.

NOTE: Call controls can be mounted to the

floor so they can be operated by your foot,

or placed on the wall and operated by hand.

Run the unit down to a few inches past the

lowest track splice.

11819 P/N: 16169 Rev D