DoorHan PCB-SH Programmieranleitung Handbuch - Seite 11
Blättern Sie online oder laden Sie pdf Programmieranleitung Handbuch für Toröffner DoorHan PCB-SH herunter. DoorHan PCB-SH 16 Seiten. Control board
Auch für DoorHan PCB-SH: Programmieranleitung Handbuch (14 seiten), Programmieranleitung Handbuch (12 seiten)
Seite drucken
Diagram of PCB-SH, traffic light and lamp
2. REMOTE CONTROLLER PROGRAMMING
2.1. SELECTING THE OPERATING MODE
Selection of operating mode is by pressing of button "P". Number of clicks will correspond to number of selected operat-
ing mode. The Program indicator shows the selected operation mode, the number of flashes corresponds to the number of the
preset mode:
Operating
Program indicator
mode
flashes
1
one time
2
two times
3
three times
4
four times
5
five times
NOTE: it is recommended to use pulse operation mode for door closing (modes 2, 4, 5) only when safety photocells are
available. It is possible to use an external radio receiver only in modes 4 or 5.
Gate
opening
pulse pressing of Open button
pulse pressing of Open button
holding of Open button
pulse pressing of Open button;
stepped behaviour
(open–stop–close)
pulse pressing of Open button;
stepped behaviour
(open–stop–close)
REMOTE CONTROLLER PROGRAMMING
v
Gate
closing
pulse pressing of Close button
pulse pressing of Close button
holding of Close button
pulse pressing of Close button
pulse pressing of Close button
Automatic
closing
no
no
no
no
yes
11