DoorHan Sectional-DIY-500 Installations- und Betriebshandbuch - Seite 12
Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Toröffner DoorHan Sectional-DIY-500 herunter. DoorHan Sectional-DIY-500 20 Seiten. Operator
Seite drucken
Operator programming
Open the lamp housing to reach key panel.
PREPARATION
Block the carriage.
If programming has not been completed, the settings will not be stored. If there is a mistake in one of the settings, you can
turn off power and reprogram.
UPPER AND LOWER DOOR POSITIONS
R
+
P
–
1 2 3
Press and hold down
the button "P" for about
5 seconds
After that programming may be completed.
FORCE SETTING
R
+
P
–
1 2 3
AUTOMATIC CLOSING SETUP
R
+
P
–
1 2 3
Open the door. Press and
hold the "+". Indicators "1",
"2", "3" will start blinking.
Automatic closing is switched
off. Release the "+"
Wait for the indicators to go out and LED-lamp to light to exit the programming menu.
12
OPERATOR KEY PANEL
R
+
P
–
1 2 3
Indicator "1" will flash.
Release the button. By
pressing "+" and "–", set the
leaf into the required upper
position
Press and hold down the buttons "P" and "R" simultaneously, indicator 3 will flash.
By pressing "+" and "–", set the force level:
•
1 flash means the first force level;
•
2 flashes mean the second force level;
•
3 flashes mean the third force level.
Press the button "P" in order to store and to exit the force menu, otherwise you will automatically exit the setting mode
in 15 seconds. The settings will be stored by default.
R
+
P
–
1 2 3
Use the "+" to choose one of
the automatic closing modes.
Press the "+" one time to
choose automatic closing in
30 sec, indicator "1" will glow
steadily
R
+
P
–
1 2 3
Press "P" for going into the
next mode. Indicator "2"
will flash. By pressing "+"
and "–", set the leaf into the
required lower position
Press the "+" twice to choose
automatic closing in 60 sec,
indicator "2" will glow steadily
ELECTRICAL CONNECTIONS
"Р" — programming key
"R" — remote control storing key
"+" and "–" — setting keys
Indicators "1", "2", "3" — show the settings
R
+
P
–
1
2
3
Press "P". Indicator "1"
will flash. The doors will
automatically open
R
+
P
–
1 2 3
R
+
P
–
1
2 3
After the doors are open,
indicator "2" will flash and
the doors will automatically
close. LED lamp will light
up, this means the end of
programming
R
+
P
–
1 2 3
Press the "+" three times to
choose automatic closing in
90 sec, indicator "3" will glow
steadily