AMERITRON SDC-105 Gebrauchsanweisung - Seite 7

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Controller AMERITRON SDC-105 herunter. AMERITRON SDC-105 11 Seiten. Automatic screwdriver antenna controller for all transceivers

Seite drucken
AMERITRON SDC-105 Gebrauchsanweisung
Note: RF has to be present during the whole tuning for Low VSWR process. If
the Sensor losses RF the controller will assume the VSWR dropped below 1.5:1
and stop tuning.
Auto Mode the controller will automatically move the antenna to the stored
location without having to press the TUNE button.
If RF is present the controller will tune the antenna if the VSWR is higher than
1.5:1.
Display:
U
Indicates the UP button is pressed
D
Indicates the Down button is pressed
R
Indicates RF is present.
S
The VSWR reating at the antenna jack of the sensor box.
P
The number of pulses or turns detective form the antenna's internal
Switch.
C
The amount of current the antenna motor is using.
F
The Frequency detected by the RF sensor.
TRIP
Indicates the motor current limit has been reached.
*
Indicates the processor is operating
HOME (Auto Park)
Home mode moves the antenna down until the current limit is reached and stops.
If the motor trip current is reach when the count is below 10 it will stop the
motor and set the counter to zero.
To enter HOME mode Press and hold the UP and DOWN buttons at the same
time until HOME is displayed.
Menus:
Pressing the SETUP button for a few seconds will allow the controller to inter
into the Menu Mode.
Momentarily pressing the SKIP button will navigate thru the following menus.
Momentarily pressing the ENTER button will allow you to make changes to that
menu. Pressing ENTER button again will save changes to that menu.
STORE This menu is used to store the location of the antenna for each band. 8
different locations can be stored for each band. If an antenna setting needs to be
change the new setting can be programmed over the old setting without having
to erase all menus.
POL Allows the direction of the antenna to be changed without having to swap
the motor wires.
7