DoorHan ARM 320 Installations- und Betriebshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installations- und Betriebshandbuch für Türöffnungssystem DoorHan ARM 320 herunter. DoorHan ARM 320 12 Seiten. Operator
Auch für DoorHan ARM 320: Handbuch (2 seiten)

Seite drucken
DoorHan is not responsible for unstable work of the automatic system when using safety devices and accessories, which
are produced by other manufactures without agreement with DoorHan.
Never leave the electric motors in released condition. This may cause uncontrolled movement of the gate leaves and,
consequently, their breakdown.
Do not use the operator if it needs repair or adjustment as installation defects or unbalanced door can cause injury.
DoorHan shall not be held liable in case of improper installation of the item and damage arisen during operation.
Since the operator does not have a power cord with a plug it shall be connected to the mains supply via automatic switch
with a minimal distance of 3 mm between the neighboring contacts. It is recommended to use a 6А double
breaker.
Be sure there are no obstructions to door travel.
Do not make any changes in the automatic system not specified in this manual.
Remove package of the item and dispose of it. Keep the package materials away from children.
Always keep remote controls out of reach of children. Never permit children to operate or play with garage door control
push buttons or remote controls.
No one should cross the pass of the moving door.
The content of the manual shall not be basis for any claim.
The manufacturer reserves the right to modify the design of the product described in this manual without preliminary
notice.
After installation, ensure that the mechanism is properly adjusted and that the protection system and any manual release
function correctly.
Installation and configuration of the actuator must only be carried out by qualified specialists.
After installing the drive, test force according to standards EN 12445 and EN 12453.
WARNING! For safe and correct operation of the operator it is necessary to install mechanical stoppers to limit gate wing
travel.

3. OPERATOR UNIT

6
7
1
2
Dimensions, mm
4
5
1. Motor-reducer
2. Straight arm
3. Curved arm
4. Manual release
4
5. Operator fastening bracket
6. Limit switches
7. Operator fastening bracket
3
340
OPERATOR UNIT
178
pole circuit-