DoorHan DH1500 Benutzerhandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Türöffnungssystem DoorHan DH1500 herunter. DoorHan DH1500 8 Seiten. Rapid rolling door operator

Seite drucken

•

Make sure the door shaft which out of the door operator about 160mm.

To install the bracket on the fix board, determine the location, mark and drill the 2 holes ( ∅11).

•

Fix the bracket on the operator with 4 screws M8x16. Make sure that the bracket is plumb and lever. See Fig.2

•

The bracket installation should meet the specifications as shown in figure 3

•

Slot the door operator with bracket onto the door shaft (ensure correct position of the key) and screw onto the fix board with

2 bolts M10x25 and 2 nuts M10.

•

Slot the encoder onto the door shaft and push it close to the door operator and screw onto the door operator with screw

M8x16.

•

Tight the screw on the encoder, make sure the encoder rotates with the shaft simultaneously.

4. WIRING

Before carry out any wiring work, it is essential to disconnect the control unit from the mains supply.

Motor

Open the wiring terminal block cover, connect motor as shown in Fig.4.

Factory preset: △ Wiring (PLC Input single-phase 220V, Output three-phase 220V)

Y Wiring (PLC Input three-phase 380V, Output three-phase 380V)

Fig. 3

Fig. 4

DH1500 Rapid Rolling Door Operator