Canon PIXMA MP499 Handbuch zur Netzwerkeinrichtung - Seite 12
Blättern Sie online oder laden Sie pdf Handbuch zur Netzwerkeinrichtung für Alles in einem Drucker Canon PIXMA MP499 herunter. Canon PIXMA MP499 24 Seiten. Obtaining network key
Auch für Canon PIXMA MP499: Handbuch zur Netzwerkinstallation (17 seiten), Netzwerk-Handbuch (22 seiten), Netzwerk-Handbuch (16 seiten), Handbuch (13 seiten), Handbuch (10 seiten)
Seite drucken
- 1. Table of Contents
- 2. The Target Access Point Is Not Displayed (Detected) on the Detected Access Points
- 3. Set Printer Ip Address Screen Is Displayed
- 4. The Machine Is Not Displayed (Detected) on the Detected Printers List Screen
- 5. Problems During Network Setup
- 6. Configuring Wireless Lan Settings Manually
- 7. Other Troubleshooting Tips
- 8. Restoring the Machine's Default Lan Settings to Perform Setup Again
Connection Checklist
Check 1
Before connecting the machine, are the computer and network device (router, access
point, etc.) configured and can the computer connect to the network?
Configure the computer and network device.
•
For the procedures, refer to the manuals supplied with the computer and network device, or
contact their manufacturers.
Check 2
Are the machine and network device (router, access point, etc.) turned on?
Turn on each device.
If the machine is already turned on, turn it off, then turn it back on.
Check 3
Are the access point and machine installed in an open space where wireless
communications are possible? Also, is there a microwave oven, refrigerator, etc.
nearby?
Install them in an open space with as few obstacles as possible.
Leave some space between the installation location and a microwave oven,
refrigerator, etc. so that its radio waves will not affect those from the access point.
Glossary
•
Firewall
A system to use computers connected to the Internet and corporate networks safely. It protects computers and corporate networks against unauthorized access, or restricts unauthorized access to corporate
networks and the Internet.
Check 4
Is the access point operating in IEEE802.11b, IEEE802.11g, or IEEE802.11n (2.4
GHz)?
•
For details on how to check the operating mode of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
Set the access point to operate in IEEE802.11b, IEEE802.11g, or IEEE802.11n (2.4
GHz).
•
For details on how to change the operating mode of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
Check 5
Is the wireless LAN setup cable connected properly?
•
The wireless LAN setup cable is required for network settings when configuring wireless
settings without using the WPS or WCN function.
Connect the wireless LAN setup cable properly.
•
For the connection procedure, refer to "Software Installation (1)" in the printed manual: Getting
Started.
Check 6
Is the firewall function of your security software active?
A message may appear on the computer monitor warning that Canon software is
attempting to access the network.
If the warning message appears, set the security software to always allow access.