DAC DA-116 Schnellstart-Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Schnurloses Telefon DAC DA-116 herunter. DAC DA-116 2 Seiten. Digital transcribe station

Seite drucken

Setup

1. Using the telephone line cord supplied, plug one end into the unit's

Telephone jack (located on the back), and the other end into the

system or phone jack.

2. Connect the power adapter to the A/C jack on the unit's right side.

3. Lift the dialer directory card and plastic off the top. Remove the

plastic tab from underneath. This activates the internal battery for dialer

memory.

4. Plug the foot control into the jack on the unit's left side.

Operation

Headset

You can use any mono headset with a 3.5mm jack. Stereo headsets

may be used with a stereo-to-mono adapter, otherwise you may only

receive audio through one side of the headset.

Plug it into the HEADSET jack on front of the unit.

Volume

The volume and tone of the audio can be adjusted using the VOL

and TONE controls on the front of the unit.

Turning the Unit On

To turn the unit on, press LOG ON.

Note: If the unit does not turn on, verify Setup steps 1-2 have been

followed.

Turning the Unit Off

To turn the unit off, press DISCONNECT.

Programming Dialers

There are 10 one-touch dialers which can be programmed. Before

proceeding, verify that you have followed Setup steps 1-3.

1. Press Log On and then connect to your system (this may require

entering a user ID and even dialing a telephone number).

2. Press Store.

3. Dial the number(s) you wish to have stored.

4. Press the one-touch dialer you desire to program.

Repeat steps 2-4 for additional dialers.

DIP Switches

There are four DIP switches located on the front of the unit, underneath

the dialer directory card. These are not used and should not be

changed.

Flash

On the back of the unit is a switch labeled FLASH. There are three

options: 600, 300, or 100. Always leave it to 600 or you may have

issues with the DISCONNECT function.