DAC Limited RA711 Benutzerhandbuch - Seite 6

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Telefon DAC Limited RA711 herunter. DAC Limited RA711 6 Seiten. Vandal resistant full keypad telephones
Auch für DAC Limited RA711: Benutzerhandbuch (12 seiten)

Seite drucken

INSTALLATION

The following information is provided for use by the approved
installer or telephone network supplier only. The RA711
telephone can be either wall mounted or top-of-pole mounted.
Wall mounting can be surface, flush or inset into the wall.
Various electrical options are available as defined under the
Electrical Connections section. Make sure that these are set
correctly before finally fitting the unit to the back box.
Wall Flush Installation
1.
Produce hole in wall 285mm high 120mm wide 60mm
deep.
2.
Use size 8 or 10 screws with rawplugs (4 off) to fix back
box into wall, with cut-out at the bottom
3.
Connect the cabling, Use a 2.5mm socket-head key for
the M4 bolts, through the 4 small holes in the front plate,
to fit the telephone unit to the back-box. Start each screw
by turning several rotations at a time until all 4 screws
are secure. To remove the telephone from the box,
reverse the procedure.
4.
Use any suitable silicone waterproofing sealant (such as
Unibond Waterproof Flexible Frame Sealant) to seal to the
wall. Leave a 12mm to 13mm (0.5") gap at the bottom
for drainage.
Page 5
Wall Surface Installation
1.
Fix the surface
mounting back box to the
wall, with cut-out at the bottom,
using size 8 or 10 screws with
rawplugs (4 off).
2.
Connect the cabling, as
detailed under Electrical
Connections, and then fit to the
back box (as described under Wall
Flush Installation, item 3).
3.
Use any suitable silicone
waterproofing sealant (such as
Unibond Waterproof Flexible
Frame Sealant) to seal to the back
box. Leave a 12mm to 13mm
(0.5") gap at the bottom for
drainage.
Top-of-pole Installation
1.
Place the top-of-pole
mounting over the top of the
pole.
2.
Tighten the grub screws
to secure the mounting.
3.
Fix the surface mounting
back-box to the top-of-pole
mounting with the screws
provided.
4.
Connect the cabling, as
detailed under Electrical
Connections, and then fit to the
back-box (as described under
Wall Flush Installation, item 3).
Page 6