Canon PIXMA MX410 Series Handbuch zur Netzwerkeinrichtung - Seite 10

Blättern Sie online oder laden Sie pdf Handbuch zur Netzwerkeinrichtung für Alles in einem Drucker Canon PIXMA MX410 Series herunter. Canon PIXMA MX410 Series 24 Seiten. Cartridge reset
Auch für Canon PIXMA MX410 Series: Handbuch zur Netzwerkinstallation (23 seiten), Spezifikationen (2 seiten), Funktion Handbuch (30 seiten), Funktion Handbuch (21 seiten), Funktion Handbuch (15 seiten), Handbuch zur Netzwerkeinrichtung (20 seiten), Manuelles Menü (34 seiten), Fehlerbehebung bei der Netzwerkeinrichtung (46 seiten), Handbuch (14 seiten), Handbuch (4 seiten)

Seite drucken
Canon PIXMA MX410 Series Handbuch zur Netzwerkeinrichtung
6-A
WEP
G
I
1
Enter the network key in WEP Key (F).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
5 or 13 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 10 or 26 characters (digits).
2
Select Key Length (G).
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select 64 bit.
When WEP (Transitional Security Network) is selected in AirPort Utility, select 128
•
bit.
3
Select Key Format (H).
Select ASCII when the network key is 5 or 13 characters.
•
Select Hex when it is 10 or 26 characters (digits).
4
Select Key ID (I).
When using AirPort, select 1 in the screen.
•
Selecting other key numbers will disable the connection between the machine and
AirPort.
5
Select Authentication (J), then click OK (K).
Go to .
WPA/WPA2
Disable
F
H
J
K
6-B
WPA/WPA2
L
1
Enter the network key in Passphrase (L).
•
Enter upper and lower case letters of the alphabet correctly when the network key is
between 8 and 63 characters. Letters are case sensitive.
Letters are not case sensitive if the network key is 64 characters.
2
Select Dynamic Encryption Type (M), then click OK (N).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select
AES(Secure Encryption).
•
When the access point is set to operate in IEEE802.11n, TKIP cannot be used.
Change the encryption type to something other than TKIP or change the standard to
something other than IEEE802.11n, then configure wireless LAN settings again.
•
When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP
set as an encryption standard, communication is established using IEEE802.11g.
Go to .
7
The Manual Setup screen returns. Click Connect.
•
After that, follow the on-screen instructions to proceed with settings.
Disable
M
N