<Confirmation test>
Using Photo Paper Pro, and with the paper thickness lever set to the left position (normal position), print an image and confirm that
the print quality is proper, and the print head is free from contacting the paper.
If the print quality is not proper, or the print head contacts the paper, adjust the head-to-paper distance in the following procedures:
<How to adjust the head-to-paper distance>
i. Mark the current position of the left boss and the right hole. (See the step 1 of the carriage rail adjustment above.)
ii. Loosen the hexagon-head screws, and adjust the head-to-paper distance.
- To prevent the print head from contacting the paper: Raise the carriage rail from the current position.
- To improve the print quality: Lower the carriage rail from the current position.
(3) Document pressure sheet attachment
< How to attach the sheet >
1) Peel off the cover sheet from the double-sided adhesive tape on the back of the document pressure sheet.
With the long-side down, position the upper-left corner of the document pressure sheet approx. 1 mm off the scanning reference
edges (back left) on the platen glass.
2) Slowly close the ADF unit. The ADF unit will attach to the plate.
< Confirmation after attachment >
1) Open the plate to confirm the following:
- No extension of the sponge edges over the mold part of the upper scanner cover.
- No gap between the platen glass reference edges and the corresponding sponge edges.
2) Open and close the plate to confirm the following:
- The sponge must not be caught by the mold part of the upper scanner cover.
(4) Sheet feeder unit adjustment
Assemble the sheet feeder unit with the swing arm (pointed by the red arrow in the photo) in the raised position.
25 / 41
Seite drucken