Dooya DC2700 Anweisungen - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen für Fernsteuerung Dooya DC2700 herunter. Dooya DC2700 2 Seiten. Motorized screen remote

Seite drucken

5 Preferred Position

Set Preferred Position

Check that both upper and lower limits are set.

Operate the screen to the desired preferred

position. Press P2 (1 jog and 1 beep), press STOP (1

jog and 1 beep), press STOP again (2 jogs and 3

beeps), preferred position is now set

Remove Preferred

Press P2 (1 jog and 1 beep), press STOP (1 jog and 1

beep), press STOP again (1 jog and 1 Long beep),

preferred position is now deleted

6 Delete All Limits

Press P2 (1 jog and 1 beep), Down and 1 beep), P2

(2 jogs and 3 beeps), all limits are now removed

7 Pair / Unpair Additional Remotes

Remote A → Remote A → Remote B

On existing remote, Press P2 (1 jog and 1 beep)

Press P2 again (1 jog and 1 beep), then on new

remote, press P2 (2 jogs and 3 beeps). New remote

is now linked. Repeat for any additional remotes

8 Remove All Remotes

Press P2 (1 jog and 1 beep), STOP (1 jog

and one beep), P2 (2 jogs and 3 beeps)

9 Motor Mode Switching

Press P2 (1 jog and 1 beep), UP (1 jog and

one beep), UP (1 jog and 1 long beep)

Troubleshooting

Issue – Possible Cause

Motor has no response - No

Power or poor wire

connection

Motor has no response -

Remote battery low

Motor has no response - RF

Interference

Motor has no response - Out

of remote control range

Motor starts slow or makes

loud noise - Incorrect

installation or overload

Motor stops during travel -

Motor has reached limit

Motor stops during travel -

Run time exceeds 4 minutes

Screen does not reach lower

limit or goes too far into the

housing – Screen has re-

wrapped itself

Solution

Check power and connections

Replace Battery

Check motor antenna, check

for other RF source

interference

Move remote closer to unit

Verify installation is correct

and level

Adjust limits

Allow motor to cool to reset

the internal thermal fuse

Remove hood and check for

re-wrap, break limits if

needed to relieve re-wrap