Flycam 5000 Montageanleitung - Seite 9

Blättern Sie online oder laden Sie pdf Montageanleitung für Kamera-Zubehör Flycam 5000 herunter. Flycam 5000 11 Seiten. Gimbal support handheld camera stabilizer
Auch für Flycam 5000: Montageanleitung (6 seiten)

Seite drucken

•

Fine-tune the left-right, forward-backward balance. You will have to go back and forth between the

two directions to get the balance just right. Loosen the screw sets that allow the sled to move left

and right. Adjust the top plate so that it is centered and tighten down the screws like you would a

tire slowly and alternating side to side.

•

Repeat for "forward-backward" balancing.

•

Check to see if your camera is sitting level. If not, repeat the necessary steps until it does.

•

Practice walking movements ensuring your body motion is not transmitted to your hands and then

the FLYCAM and camera.

Maintenance

Bearing Maintenance:

Central Post about two inches from the top. It is of metal construction and partially enclosed by the

Bearing assembly. If after a period of time your bearings don't turn smoothly, lubricate with a

minimum of light machine oil. Light lubricating oil can also be used on the Yoke and Handle Bearings.

Be sure to keep oil away from your camera, & clean up any over spill.

Cleaning:

Do not use solvents or harsh cleaners of any kind on your Flycam Hand held stabilizer. If

the unit becomes dirty, use a damp soft cloth or sponge and a mild detergent to gently clean external

parts.

Storage:

Should you need to store your Flycam Hand held stabilizer for a long period of time then

place the unit upright in a dry or low to normal humidity area whenever possible. If you are unable

to find this kind of environment then we suggest you store the unit in an airtight plastic container or

bag. Standing the unit upright is preferred as it alleviates stress on the system.

NOTE: Flycam 5000 Stabilizer doesn't work under water, nor is it waterproof. Avoid direct exposure

to rain, water spray or any harsh environment. The bearings are not sand proof. Avoid getting dirt or

sand in them.

The main Bearing on your Flycam Handheld Stabilizer is attached to the