Flycam DSLR-NANO-QR-BL Montageanleitung - Seite 9
Blättern Sie online oder laden Sie pdf Montageanleitung für Kamera-Zubehör Flycam DSLR-NANO-QR-BL herunter. Flycam DSLR-NANO-QR-BL 10 Seiten. Dslr nano blue handheld camera stabilizer
Seite drucken
•
You'll get one that's too slow and then you'll add a pair and it will fall too fast. When that happens, take
off the last pair of weights that you added.
•
Tighten down the weights so they don't slide around.
•
To get the count perfect, slightly lower the center post that attaches the Base Platform with the weights
until you get the "one-one thousand, two one thousand" count to the vertical position.
•
Fine-tune the left-right, forward-backward balance. You will have to go back and forth between the two
directions to get the balance just right. Loosen the screw sets that allow the sled to move left and right.
Adjust the top plate so that it is centered and tighten down the screws like you would a tire slowly and
alternating side to side.
•
Repeat for "forward-backward" balancing.
•
Check to see if your camera is sitting level. If not, repeat the necessary steps until it does.
•
Practice walking/movements ensuring your body motion is not transmitted to your hands and then the
Flycam and camera.
Holding your Flycam Stabilizer
When handling your DSLR Nano one hand holds
onto the handle while the other is used to
gently guide the camera in the direction you
wish to shoot and frame the shot.
For normal shooting, hold the handle in the
middle.
For shots that require framing the camera up,
down or sideways, hold the handle firmly at the
bottom.
This will allow the "yoke" part of the gimbal to
rotate without hitting your hand or knuckles
Maintenance
Bearing Maintenance:
about two inches from the top. It is of metal construction and partially enclosed by the Bearing assembly.
If after a period of time your bearings don't turn smoothly, lubricate with a minimum of light machine oil.
Light lubricating oil can also be used on the Yoke and Handle Bearings. Be sure to keep oil away from your
camera, & clean up any over spill.
Cleaning:
Do not use solvents or harsh cleaners of any kind on your Flycam DSLR Nano. If the unit
becomes dirty, use a damp soft cloth or sponge and a mild detergent to gently clean external parts.
Storage:
Should you need to store your FLYCAM DSLR Nano for a long period of time then place the unit
upright in a dry or low to normal humidity area whenever possible. If you are unable to find this kind of
environment then we suggest you store the unit in an airtight plastic container or bag.
The Main Bearing on your FLYCAM DSLR Nano is attached to the central post
9