Air Force Pro 80 Handbuch für Betrieb und Wartung - Seite 3

Blättern Sie online oder laden Sie pdf Handbuch für Betrieb und Wartung für Power Pump Air Force Pro 80 herunter. Air Force Pro 80 17 Seiten. Air force pro 15; 40; 60; 80 linear air pump, oil-less compressor

Seite drucken
If the plug or outlet does get wet DO NOT UNPLUG THE CORD; Disconnect the fuse or
6)
circuit breaker supplying power to the pump, then unplug and examine for the presence of
water in the outlet.
DO NOT use the pump near volatile liquids such as gasoline, thinners, etc,. as this creates
7)
the possibility of an explosion.

CAUTIONS FOR USE

Close supervision is necessary when an air pump is used by or near children.
1)
This pump is intended for clean, dry air only. DO NOT, under any circumstances, attempt
2)
operation with water or other liquids, otherwise pump may be damaged.
The ambient operating temperature for this pump is between 41℉(5℃) and 104℉(40℃).
3)
Operation of pump in temperatures outside the recommended temperature range may result
in malfunction or severely shortened service life.
DO NOT block the air from being discharged. Air pumps must have sufficient room to allow
4)
for heat dissipation.
Failure to observe cautions will cause the pump to automatically switch off until cool.
5)
DO NOT REMOVE PUMP CASING UNLESS UNIT IS DISCONNECTED
Always unplug pump prior to servicing. Grasp plug to remove cord from outlet. DO NOT
6)
remove by pulling on power cord.
DO NOT use the air pump for other than its intended use. The use of attachments not
7)
recommended or not sold by Sunlight Supply, Inc may cause an unsafe condition.
DO NOT install pump where it will be exposed to weather.
8)
DO NOT store pump in temperatures below freezing.
9)
Ensure pump is securely mounted prior to operation.
10)
Read and observe all important markings on pump.
11)
Ensure that extension cords (if required) have the correct or higher rating (amperes or watts).
12)
Ensure cord is properly positioned to avoid tripping.
To avoid injury, DO NOT contact moving parts or hot parts.
13)
Always unplug an appliance from an outlet before putting on or taking off parts,before
14)
cleaning and when not in use
FROM MAIN POWER SUPPLY.
3
3