Flycam FLCM-RK-AB Montageanleitung - Seite 7

Blättern Sie online oder laden Sie pdf Montageanleitung für Kamera-Zubehör Flycam FLCM-RK-AB herunter. Flycam FLCM-RK-AB 11 Seiten. Arm brace support

The heavier the camera and accessories, the more weights are required to achieve proper balance.

Generally as you add weight to one side of the central post, an equal amount has to be added to the

other side to maintain horizontal balance.

However if you are using an offset configuration such as a flip out viewfinder or off center accessories,

extra weights might be needed on the opposite side of the post to counter act and maintain proper

balance.

Total weight fixed to the base platform should be equal to the weight of your camera plus the head and

any accessories.

Horizontal Adjustment

made by loosening the retaining screws and

moving counterweight plates closer to or

farther away from post and then re-tightening.

You will probably need to adjust and re-adjust

the horizontal position to achieve optimum

performance.

NOTE: When adding weight in cups, use the

supplied foam spacers as silencers to prevent

metal to metal washer noise.

Vertical Adjustment

post is made by loosening control knob, raising

or lowering post to desired height and then

retightening the knob. Do not over-tighten this

knob as it could cause thread stripping.

Balancing your Flycam Stabilizer

Before beginning the balancing process check the following:



Camera is securely attached to Head Plate



Lens cap is removed and secured



Telescoping Clamp is tightened



Weight discs are added successfully



All screws are tightened securely



Battery, all accessories and cables are secured

on base platform is

of telescopic central