Dor-O-Matic 96000 Series Installationsanleitung Handbuch - Seite 6

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Controller Dor-O-Matic 96000 Series herunter. Dor-O-Matic 96000 Series 7 Seiten. Slide control

Seite drucken
1.
Keypad Label
2.
Setting Down
3.
Setting Up
4.
Value Down
5.
Value Up
6.
Default Setting Push Button
7.
Description Label
8.
Transformer
9.
J10B
4.
Operational Walk-Through Test:
NOTE: It is assumed that during the installation process, any problems would have been found and corrected before this point. However, it is
recommended that a complete walk-through test now be performed.
A.
Give the system an activation signal. The door should open smoothly and silently to the back check point, where it should slow down rapidly
and drift into the fully open position without slamming.
B.
Maintain the activation signal to verify that the door does NOT time out and close while being activated.
C.
If a door safety device is used, step into the door opening. Remain in the door opening making sure that the door does NOT close.
D.
Step out of the door opening. After both the activating area and door opening are clear, the door should time out at the pre-set time delay and
begin to close. The door should close quietly and smoothly to the latch point, where it rapidly slows down and drifts into the fully closed
position without slamming.
5.
Release of the System for Use:
A.
Remove all tools and installation equipment, and clean any debris from the vicinity of the door.
B.
Install all safety, traffic control, and instruction decals to the door as required. THIS IS VERY IMPORTANT! Failure to do this leaves the
installer LIABLE for any accident that might occur. THIS MUST BE DONE!
C.
Verbally explain the proper operation of the door system to the owner or to the person in charge.
6.
For Doors that are manually/mechanically secured:
A.
Locking:
1)
Place switch in "OFF"
2)
Allow door to close completely
3)
Secure door
B.
Unlocking inside:
1)
Unsecure door
2)
Place switch in "1-WAY" or "2-WAY"
3)
Activate door once
C.
Unlocking outside:
1)
Unsecure door
2)
Activate morning entry or manually open door
3)
Place switch in "1-WAY" or "2-WAY"
84657-084 REV. B
10.
J10C
11.
J10A
12.
Test Activate Push Button
13.
Value Display
14.
Setting Display
15.
J7 (Transformer Secondary)
16.
J8 (Sensor Power)
17.
F2 (Sensor Fuse)
18.
J9 (Transformer Primary)
FIGURE 3: CONTROL BOX FEATURES
CB1 (MOTOR/CONTROL CIRCUIT BREAKER)
July 2003
19.
J1 (AC In)
20.
CB1
21.
F1 (Main Fuse)
22.
J3 (Hall Effect Sensor)
23.
J2 (Factory Wired Sensors)
24.
J5 (Electric Lock Circuit)
25.
J6 (Not Used)
26.
J4 (Motor Drive)
Page 6 of 7