Canon 4200F - CanoScan Flatbed Scanner Schnellstart-Handbuch - Seite 12
Blättern Sie online oder laden Sie pdf Schnellstart-Handbuch für Scanner Canon 4200F - CanoScan Flatbed Scanner herunter. Canon 4200F - CanoScan Flatbed Scanner 17 Seiten. Canon canoscan 4200f: quick start
Seite drucken
Scanning Film
3
Insert a fingernail into the slot in the Film Guide and open the Film Holder.
4
Insert the film into the Film Guide.
• Hold the film by the edges with your fingertips to avoid getting fingerprints or dirt
on the film surface.
• Use a blower brush to remove any dust from the film, document glass or light source
unit.
• Do not block the calibration slot on the Film Guide when you are scanning film.
Colors will not be scanned correctly if the calibration slot is obstructed.
Place the film face down with the frames in reverse order. Close the film holder.
Film Strip
Calibration Slot
• Ensure that there is no gap between the edge of the film and the Film Guide on the
side near the calibration slot.
• Close the film holder securely. Press lightly above the three slots until it clicks into
place.
Scanning Curled Film
When curled film is scanned, extra light will enter
through any gaps and produce bands of color around
the edges of the scanned image. If this occurs, use the
supplied shield to hold down the film and block the
light as shown in the figure.
12
Slides
Calibration Slot