Akw Onyx Exclusif Installationsanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationsanleitung Handbuch für Armaturen für das Badezimmer Akw Onyx Exclusif herunter. Akw Onyx Exclusif 8 Seiten. Shower tray

Seite drucken

Important Information

Specification

•

tray height: 26 mm

•

Slate finish

•

smC waste cover

•

Concealed waste

•

High water flow rate*

•

Weight load: 200 kg

•

Webbed back reinforcements

•

material: smC (sheet moulding Compound)

* Flow rate depends on the waste.

Placement

Suitable for 'on floor' or 'in floor' installations.

For wooden floor installation, use a suitable

grab adhesive.

For solid floor installation, use a mix of 6:1

sand and cement to secure the tray down into

position. It is recommended when removing

solid floor material, to remove a minimum depth

of double the thickness of the tray.

Ensure that the floor levels are tested before

and after the installation, water test the flow from tray into waste for correct installation and

drainage efficiency. It is important to ensure that the floor is level in all directions before

putting the tray into place. If water puddles away from the waste, this is a clear indication that

the levels are not correct. the water must drain towards the waste.

the sides of the tray A and B may well show level on testing, but if point C is low, then water

will puddle in the area of point C and the only remedy is to level the floor and refit the tray. The

tray has 'lands' on all four sides. Use a spirit level front to back and side to side - all 'lands' must

be level (ABC) - the fall is moulded into the tray.

Trimmable Trays

Trimmable to within 150 mm of waste.

If trimming is absolutely necessary to avoid

obstructions or tricky installations then onyx

trays can be trimmed down to within 150 mm

of the waste cover area. the sides on the tray

X and Y shown are shaded out to show the

trimmable areas.

General: 01905 823 298