ASTRO U 100-230 Betriebshandbuch - Seite 5
Blättern Sie online oder laden Sie pdf Betriebshandbuch für Medienkonverter ASTRO U 100-230 herunter. ASTRO U 100-230 16 Seiten. Base unit
Auch für ASTRO U 100-230: Betriebshandbuch (8 seiten)
Important safety information
Operating Manual U 100-230 and U 100-48 -
To avoid any potential risks to the greatest extent possible, you must adhere to the following safety
information:
:
ATTENTION
to electrical and thermal dangers!
Proper use
Only use the device at the approved operating sites and in the ambient conditions allowed (as
described in the following), and only for the purpose described in the section "Proper use".
Before starting operation of the device
:
NOTE
Read this operating manual attentively! It contains important information about
installation, ambient conditions and maintenance of the device. Keep this operating manual for
future use and for handover in the event of a change of owner or operator. A PDF version of this
manual is available to download on the ASTRO website (there may be a more recent version).
Check the packaging and the device for transport damage immediately. Do not start operation of
a device that has been damaged.
Transporting the device by the power cable may damage the mains cable or the strain relief, and
is therefore not permitted.
Installation and operation
The device may only be installed and operated by qualified persons (in accordance with EN
60065) or by persons who have been instructed by qualified persons. Maintenance work may only
be carried out by qualified service personnel.
The installation site must be planned in a way that prevents children from playing with the device
and its connections.
In order to prevent inadmissible operating statuses from occurring, only the components described
in this manual, or components approved by the manufacturer for the base unit, may be used.
In order to operate the U 100-230 unit (protection class I), it must be connected to mains sockets
with a protective earth conductor.
The U 100 base unit may only be installed using guide rails! If the device is only affixed by the
screws in the front panel, this will damage the base unit.
The electrical connection conditions must correspond to the specifications on the device type
plate.
To avoid damage due to overheating, the device may only be installed on horizontal surfaces. The
device is primarily designed for operation in metallically conductive 19" racks with sufficient air
convection. The installation surface should be non-flammable.
The ambient temperatures specified in the technical data must be complied with, even when
climatic conditions change (e.g. due to sunlight). If the device overheats, the insulation used to
isolate the mains voltage may be damaged.
The device and its cable may only be operated away from radiant heat and other sources of heat.
To avoid trapped heat, ensure there is good ventilation on all sides (minimum interval of 20 cm to
other objects). Installing the device in a niche or covering the ventilation openings is not permitted.
No objects may be placed on the device.
Version 04-2018A
Failure to observe this safety information may result in personal injury due
Important safety information
Page 5