Doran 360SL Betriebshandbuch - Seite 5

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Prüfgeräte Doran 360SL herunter. Doran 360SL 9 Seiten. Programming tool

III. ENTERING DATA INTO THE TOOL

5. When you are sure the number that you input into the tool is correct you can press the ENTER

button to lock this number into the programming tool.

6. To select the Trailer ID number use the up and down arrow buttons to move the arrow to select

this and press the ENTER button. The first digit of the 6-digit trailer number will begin to flash.

Again, if a number is present it could be the number from a previous Read Information .

7. You can enter up to a 6 digit user defined number for the trailer ID by using the numbers on the

tool s keypad. This is provided so the driver can match the monitor s reference trailer number

to the numbers displayed on the trailer.

8. When you are sure the 6-digit number is correct, press the ENTER button to lock the number to

the tool. The right and left arrow keys allow making corrections.

9. Press the MENU button to return to the main menu.

ADD SENSOR TO TRAILER: This mode allows the selection of which tire positions are to be used

for the booster and what sensor numbers will be assigned to them.

1. In the main menu use the arrow buttons to select ADD SENSOR TO TRAILER.

2. Press the ENTER button and the display will show all tire positions available for programming

(see Figure B).

Figure B

3. Use the arrow buttons to select a wheel position where you want to program a sensor.

4. Press the ENTER button and the farthest left number of the sensor ID number will begin to flash.

If the READ INFORMATION FROM BOOSTER has been used, or the position has previously

been set, that ID number will be displayed. All programmed positions will be shown with solid /

shaded tire positions.

5. Using the numeric keypad you can change the number. When the sensor ID number has been

inputted the pressure number will begin to flash. The system is set at the factory for 100 psi.

If you do not need to change it, you can press the ENTER button to lock all information for that

wheel position.

6. Use the arrow buttons to select the next wheel position to program and repeat the steps above.

7. When all positions have been entered and the ENTER button was pressed for the last entry,

the MENU button can be pressed to return to the main menu.

000-000-000-000

Baseline: 100PSI