Ametek Sorensen DLM600 M6 Handbuch Addendum - Seite 10
Blättern Sie online oder laden Sie pdf Handbuch Addendum für Stromversorgung Ametek Sorensen DLM600 M6 herunter. Ametek Sorensen DLM600 M6 15 Seiten. Option for m9g, m130 or m131
2.1.7 GPIB Address Switch
The GPIB SET UP DIP switch on the rear panel should always have the top switch
REM on the ON position, for remote only. The front panel REM indicator should be on
(green) at power up.
3.1 IEEE 488.2 and SCPI COMMAND OPERATION
The M9 and Relay PCB operation by remote programming using the M9 IEEE-488.2 and
SCPI command sets are described in the section 3 of the M9 programming manual.
3.1.1 Useful Instructions
The isolation relays may be accessed using the following instructions:
If the CAL:MOD:POWERON "ON,INIT" command has been previously stored in the
memory, then the following commands apply:
OUTP:ISOL ON
OUTP:POL ON
OUTP:SENS ON
If the CAL:MOD :POWERON "OFF,INIT" command has been previously stored in the
memory, then the following commands apply:
OUTP:STAT ON
OUTP:SENS ON
3.1.2 Additional Related Instructions
CAL:MOD:ISOL 0
CAL:MOD:RESET "OFF,INIT"
CAL:MOD :POWERON "ON,INIT"
FIXED OUTPUT POWER SUPPLY:
CAL:INIT:VOLT <value>
CAL:INIT:VOLT:PROT <value>
CAL:INIT:CURR <value>
MEMORY STORAGE INSTRUCTIONS:
CAL:UNLOCK "6867"
8
;Closes the output relays (K1 and K3)
;Open K1 and K3 and close K2 and K4. Note that the algebraic sign
;of the voltage value must match the state of the polarity relay.
;Closes the external sense relay (K5). Note: this instruction, if required by
the application, must be entered after the isolation (ISOL) instruction was
sent.
;Closes the output relays (K1 and K3)
;Closes the external sense relay (K5). Note: this instruction, if required by
the application, must be entered after the isolation <OUTP:STAT ON>
instruction was sent.
;Relay open at power up
;Relay to remain open after reset
;Output goes to On state and is initialized
;To store a fixed V-out available at power up
;Over-voltage protection
;To store a fixed I-out available at power up
;Security code to unlock and store
Addendum