Flying Legends P-51D Mustang Gebrauchsanweisung - Seite 9

Blättern Sie online oder laden Sie pdf Gebrauchsanweisung für Spielzeug Flying Legends P-51D Mustang herunter. Flying Legends P-51D Mustang 16 Seiten.

Seite drucken

Step 21

Connect the closed loop cables to the rudder as shown.

Now the rudder can be re-fitted by installing the hinge

pin and the tailwheel unit can be installed in its mount.

Adjusting the tension of the closed loop is done before

the tailwheel unit is permanently installed, so secure the

tailwheel unit with only a couple of screws to check, then

undo these screws and slide the rudder back to allow the

clevis adaptors to be screwed in or out as required.

Step 22

Remove the rudder servo cover from the rear of the

fuselage and screw the rudder servo in position and

re-fit the servo cover. Install the prepared pushrod.

Step 23

The DA-85 is one of the most commonly available and

suitable petrol engines for the P-51D Mustang. Use the

following template to mark the positions of the holes

required in the factory built engine-mounting box. Other

engines are suitable for this model - simply adjust the

positions of the mounting holes accordingly.

Remove the cowl from the model and test fit the engine

mounting box. Mark the top of the box and remove.

Cut out the engine mounting drill template below and

temporarily paste it to the mounting box as shown.

Proceed to the next page for the Full Size Mount Diagram

Section: Engine