Astro Tool 615717 Handbuch - Seite 2
Blättern Sie online oder laden Sie pdf Handbuch für Crimpwerkzeug Astro Tool 615717 herunter. Astro Tool 615717 2 Seiten. 8-step adjustable crimp tool
Seite drucken
GAGING INSTRUCTIONS
Gaging the tool requires the M22520/3-01 Gage
Pin Assembly, Astro part # 615716.
1. Set the tool to selector setting # 8.
2. Close the handles to the fully closed position.
3. Holding the tool closed, insert the GO pin into
the indenter opening as shown, see figure # 1 The
gage must pass freely between the indenter tips.
4. Holding the tool closed, insert the NO GO pin
into the indenter opening. The gage pin must NOT
go between the indenter tips.
CAUTION:
DO NOT CRIMP GAGE.
TOOL DAMAGE WILL RESULT.
Astro manufactures the ATK6003 gaging kit
with gage pin assemblies for each selector setting.
Contact the factory for price and availability.
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION • 21615 S.W. T-V HWY. • BEAVERTON OREGON 97003
Figure # 1
503-642-9853 • FAX 503-591-7766
GAGING INFORMATION
( Dimensions in inches )
SELECTOR
SETTING
NUMBER
1
2
3
4
5
6
7
8
TOOL SERVICE
Astro Tool's 615717 Crimp Tool is designed for
long, reliable service. If the tool becomes
inoperative or does not gage properly, it is
suggested that you contact our Customer Service
Department for a Return Goods Authorization
number and return the tool to our factory.
Upon receipt of the tool, Astro will inspect and
overhaul each tool to put the tool back into
acceptable and efficient operating condition. Worn
parts will be replaced or repaired. Please note that
Astro's Quality Control system is traceable to The
National Institute of Standards and Technology
(N.I.S.T.).
Service charges for tools not under warranty will
be advised upon request.
Parts that Astro deems to have been damaged
due to neglect, misuse or accident; and parts that
have been altered or repaired by persons other than
Astro Tool Corp. employees will be replaced
subject to additional charge for such parts.
TOOL HAS BEEN PERMANENTLY LUBRICATED
AT THE FACTORY
2
GO
NO GO
SIZE
SIZE
± .0001
±.0001
.0130
.0180
.0160
.0210
.0190
.0240
.0220
.0270
.0260
.0310
.0300
.0350
.0340
.0390
.0390
.0440
DO NOT OIL
9-26-14 TI717-12-4