Ametek esd NX30 Schnellstarthandbuch und Sicherheitshinweise - Seite 4

Blättern Sie online oder laden Sie pdf Schnellstarthandbuch und Sicherheitshinweise für Schalter Ametek esd NX30 herunter. Ametek esd NX30 17 Seiten.

AMETEK CTS

Safety

Observe all precautions to assure your personal safety. The generators comply with Installation Category II

(excess voltage section).

Pay special attention to safety and operation details!

Take note of the following explanations of the symbols used ensure safe during operation of the equipment.

*CAUTION"

"WARNING"

Power Supply & Charger

The must be connected with mains power not to exceed 250 volts between phase and neutral or between phase

and ground. A proper ground connection through the ground connector of the power cord is essential for safe

operation.

Grounding the Generators

The generators must be grounded through the power cord. To avoid electric shock, plug the power cord into a

properly installed receptacle which was tested by a qualified electrician. Have the test performed before con-

necting equipment.

Without the protective ground connection, all parts of the generators are potential electric shock hazards. This

may include components which appear to be insulated. The equipment MUST NOT BE USED if this protection

is altered.

Use the Proper Power Cord

Use only power cords and connector specified for your product. Use only power cords in good condition.

Do Not Remove Covers or Panels

To avoid personal injury, do not operate the generators without panels and covers.

Do Not Operate in an Explosive Environment

Electric Overload

Never apply power to a connector which is not specified for that particular voltage/current.

Quick Start and Safety Guide

This symbol warns of a potential risk of shock hazard. The symbol on an instrument shows that

that it can source 1000 volt or more, including the combined effect of normal and common mode

voltages. Use standard safety precautions to avoid personal contact with these voltages.

This symbol indicates where a caution is required. Refer to the operating instructions located in

the manual in order to protect against personal injury or damage the equipment.

Indicates protective Ground Terminal

GROUND

The "CAUTION" symbol indicates a potential hazard. It calls attention to a procedure, practice or

condition which, if not followed, could possibly cause damage to equipment. Such damage may

invalidate the warranty. If a "CAUTION" is indicated, do not proceed until its conditions are fully

understood and met.

The "WARNING" symbol indicates a potential hazard. It calls attention to a procedure, practice

or condition which, if not followed, could possibly cause bodily injured or death. If a "WARNING"

is indicated, do not proceed until its conditions are fully understood and met.

V 1.0

ESD Simulators

4 / 17