Astro Tool TGV300 Kurzanleitung
Blättern Sie online oder laden Sie pdf Kurzanleitung für Elektrowerkzeug Astro Tool TGV300 herunter. Astro Tool TGV300 2 Seiten. 8-step adjustable crimp tool
Seite drucken
Turret Ring
TGV300 8-STEP ADJUSTABLE CRIMP TOOL
GENERAL
The Astro Tool TGV300 8-step crimp tool is a cycle
controlled, precision crimp tool capable of crimping
wire barrel sizes 12-8.
Observe the precision ratchet action by opening and
closing the tool several times. Note that the tool cannot
be opened without fully completing the crimp cycle.
When held, the tool fits your hand for less fatiguing one
hand operation.
BASIC TOOL OPERATION
NOTE: For proper crimping, the Basic Tool must be
used with an appropriate Positioner.
1. Select the proper Positioner or Three Position
Turret Assembly for the contact to be crimped.
2. Attach the head to the turret ring on the tool using
the captive socket head cap screws. A 9/64 hex wrench
is required. Verify that the guide pin is properly located
prior to tightening the cap screws.
ASTRO TOOL CORP.
CONNECTOR ASSEMBLY TOOLING
SE L
NO .
Adjustment Knob
3. Consult the Data Plate for correct selector setting.
Raise and rotate Adjustment Knob until the proper
selector setting is lined up with the arrow on the Top
Handle. Release the Adjustment Knob. The tool is now
ready to crimp.
4. Insert the wire and contact through the Indenter
Opening and into the Positioner Assembly. Squeeze the
handles until the Tool comes to a positive stop. Release
the handles and the tool will return to the full open
position.
5. Remove the completed crimped assembly.
Do not press down on the wire during the crimp cycle.
1
CAUTION:
5-22-15 TIGV3094-1