ASTRO TOOL Corp. 11545 Anweisungen - Seite 2

Blättern Sie online oder laden Sie pdf Anweisungen für Elektrowerkzeug ASTRO TOOL Corp. 11545 herunter. ASTRO TOOL Corp. 11545 2 Seiten. Terminal hand crimping tool

Seite drucken
Squeeze the handles together until the positive stop is
reached. The tool will release and return to the fully open
position.
Remove the crimped splice and wire.
GAGING
Gaging the tool requires Astro part number 612406.
Set the tool on the #26-18 setting.
Holding the tool closed, insert the GO pin between the dies
on the wire side. The gage should pass freely between the dies.
Holding the tool closed, insert the NO-GO pin between the
dies on the wire side. The gage must NOT pass between the
dies. See figure # 3.
Gage Pin
CAUTION:
DO NOT CRIMP GAGE.
TOOL DAMAGE WILL RESULT.
ASTRO TOOL CORP. MANUFACTURERS OF INSERTION, REMOVAL,
CRIMP TOOLS AND CONNECTOR SERVICE KITS
ASTRO TOOL CORPORATION • 21615 S.W. T-V HWY. • BEAVERTON OREGON 97003
Wire Side
Figure #3
503-642-9853 • FAX 503-591-7766
GAGING INFORMATION
Contact Side
Selector
GO
±.0001
Setting
12/10
.1270
16/14
.0960
26/18
.0960
TOOL SERVICE
Astro Tool's 11545 Crimp Tool is designed for long,
reliable service. If the Tool becomes inoperative or does not
gage properly, it is suggested that you contact our Customer
Service Department for a Return Goods Authorization number
and return the Tool to our factory.
Upon receipt of the Tool, Astro will inspect and overhaul
each Tool to put the Tool back into acceptable and efficient
operating condition. Worn parts will be replaced or repaired.
Please note that Astro's Quality Control system is traceable to
The National Institute of Standards and Technology (N.I.S.T.).
Service charges for tools not under warranty will be
advised upon request.
Parts that Astro deems to have been damaged due to
neglect, misuse or accident; and parts that have been altered or
repaired by persons other than Astro Tool Corp. employees
will be replaced subject to additional charge for such parts.
TOOL HAS BEEN PERMANENTLY LUBRICATED
AT THE FACTORY
DO NOT OIL
2
Wire Side
NO-GO
GO
NO-GO
±.0001
±.0001
±.0001
.1310
.1610
.1750
.1010
.1160
.1360
.1010
.1040
.1240
5-21-15 TI545-93-1