Ametek 081712 Service- und Teilehandbuch - Seite 6
Blättern Sie online oder laden Sie pdf Service- und Teilehandbuch für Gebläse Ametek 081712 herunter. Ametek 081712 13 Seiten. Direct drive regenerative blower
Seite drucken
Impeller Shimming Procedure:
WARNING: This unit may be difficult to shim. Extreme care may be exercised.
Tools Needed: Machinist's Parallel Bar
Measure the Following:
Measurements (A) and (B) are made by laying the parallel bar across the housing flange face and
measuring to the proper points. Each measurement should be made at three points, and the average
of the readings should be used.
Shim Thickness = B – (A+C)/2
After the impeller installation (step #4 above) the impeller/cover clearance can be checked with feeler
gauges, laying the parallel bar across the housing flange face. This clearance should nominally be
(A-C)/2.
Vernier Caliper with depth measuring capability
Feeler gauges or depth gauge
Distance from the flange face to the housing (A)
Distance from the flange face to the motor shaft shoulder (B)
Impeller Thickness (C)
B
5
C
A
Revised – June 2016