Astrolux EC01 Benutzerhandbuch - Seite 2

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Taschenlampe Astrolux EC01 herunter. Astrolux EC01 4 Seiten.

UI Diagram
Not everything is covered in the diagram, please read the text.
-5-
Default UI: Smooth ramping
This UI provides smooth dimming of the light output
between FLOOR (lowest level) and CEILING (highest
level), with an easily accessible 100% TURBO mode.
Switch to STEPPED RAMP:
Turn the lamp ON: single-click the button, the EC01
Ramp up; brighter: hold the button
Reverse ramp:
Ramp down; darker: Click, hold, when ON
Instant top CEILING: from OFF: double-click
TURBO:
FLOOR / MOON mode:
Battery check:
Turn the EC01 OFF: single-click
-6-
UI: Stepped ramping
Using this UI the output does not ramp, it steps from
one mode to the next using hold. The firmware tries to
optimize these steps as equally-spaced on a cube-root
curve (considered an ideal mode-spacing by many).
If the lamp is ON:
In STEPPED RAMPING you can choose how many steps
Three clicks
you want. (See Ramp configuration for details).
(Hint: If you use 3 clicks from
OFF you engage battery check)
All operations are the same as in smooth ramping
Switch to SMOOTH RAMP: when the lamp is ON:
turns ON using the previously
Three clicks (Hint: If you use 3 clicks from OFF you engage
used light output level (MEM)
battery check)
UI: Momentary mode
while ramping in one direction,
5 clicks from OFF to enter Momentary mode
release button briefly and hold
To exit this
again
(unscrew the
This mode locks the flashlight into a single-mode
interface where the LEDs are only on when the button
(means: double-click, but hold
is held down. It is intended for Morse code and other
the second click a bit longer)
signaling tasks.
If you do this when the lamp is
Brightness is the last-ramped level, so adjust that
OFF, it ramps down from the
before entering momentary mode.
CEILING (dashed double lines)
UI: Muggle mode
(double lines)
Muggle mode is for lending the EC01 to others. It has a
reduced output to make sure somebody won't start a
from ON: double-click toggles
fire. An extremely simple interface with a limited
between
turbo
and
the
brightness range —
memorized level
smooth ramping and no blinkies. Persists after a battery
from OFF (You must first switch
change.
ON): Click, then double-click
MUGGLE mode ON: from OFF 6 clicks to enter
from OFF: Hold
turns on at the FLOOR level, it
MUGGLE mode OFF: 6 clicks to exit
makes a subtle "blink" to provide
One click ON / OFF and HOLD to ramp up / down.
a timing hint if you want to stay
there.
UI: Electronic Lockout
If you keep holding, it ramps up
4 clicks form OFF to disable the EC01, same to re-
from OFF: triple-click (4 blinks, a
enable the lamp.
short pause, then 1 blink would
Lockout makes the light safe to carry in a pocket or a
indicate 4.1 V)
bag or anywhere else it might be pressed by accident.
Lockout doubles also as a momentary moonlight mode,
so the user can do quick tasks without having to unlock
the light. It uses the FLOOR of the current ramp.
-7-
mode, physically disconnect power
light).
~5 lm to ~240
lm, with slow
-8-