Coldelite KW-77 Betriebshandbuch - Seite 7

Blättern Sie online oder laden Sie pdf Betriebshandbuch für Getränkedispenser Coldelite KW-77 herunter. Coldelite KW-77 15 Seiten. Counter model whipped topping dispenser

Seite drucken

B) Mix Injection Pump

Your Coldelite whipped topping dispenser is

equipped with a mix injection pump. This mix

injection pump injects air into the liquid mix

prior to dispensing. This pump has two internal

gears that are driven by a pump drive shaft. This

drive shaft couples with the pump motor through

a pulley and a belt.

The mix injection pump runs whenever the pump

drive motor is turning. To regulate the amount of

mix being dispensed, pivot the pump suction tube

either to the right (less mix/more air) or to the left

(more mix/ less air). (Refer to figure 3)

max

Figure 3

The air intake is through the front two holes of

the pump cover. Since the two air inlet holes are

fixed, the air intake is constant. To adjust your

overrun (yield) you must regulate the amount of

mix being pumped. The mix pump suction tube

will change the orifice size on the tube to allow

either more or less mix to be pumped.

You will also have to adjust your pump suction

tube orifice setting depending on your product

viscosity and texture desired.

The "Normal" operating position for the suction

tube on this dispenser is either one position to the

left, center, or one position to the right of center.

C)Texturizer and Dispensing Head

The texturizer and dispensing head are also

important parts used to dispense whipped product

from this machine.

The texturizer is used to whip the product that is

pressurized by the mix injection pump. The

texturizer consists of a stainless steel rod

enclosed inside a clear plastic tube. The

texturizer and tube are connected to the pump

cover on one end and the dispensing head on the

other end. The pressurized liquid is pumped

through the channeled texturizer, which whips

the product. The whipped product is then

transferred to the dispensing head and dispensed.

The dispensing head is made of high impact

thermo-plastic. This dispensing head is secured

to the machine by two pins attached to the

refrigerated front extension. To remove the

min

dispensing head, simply rotate the head counter

clockwise ½ a turn while pulling straight out.

Attached to the head is a pattern nozzle and

splashguard. These parts are secured to the

dispensing head with rubber orings.