Daessy DSAM4 Montageanleitung Handbuch - Seite 4

Blättern Sie online oder laden Sie pdf Montageanleitung Handbuch für Wheelchair Daessy DSAM4 herunter. Daessy DSAM4 6 Seiten. Swing aside mount

Seite drucken

Align the Frame Clamp Assembly

This step requires 3 components:

• Wheelchair

• Frame Clamp Assembly (loosely attached to chair)

• Vertical S-bend Tube (ROP Attached)

Slide the Vertical S-Bend Tube into the Frame Clamp Assembly. Use the tube as a lever in the outer

piece to align the Frame Clamp Assembly.

Sideways alignment: Hold the Vertical S-Bend Tube parallel to the

wheelchair and tighten the Frame Clamp "Cap" bolts alternating between

each bolt.

When completely tight there should be a gap of 1/32" to 1/64" between the Cap & Body of

Forward/Backward Alignment

Align the Vertical S-Bend Tube then carefully remove the tube to access the

Swivel Clamp bolts taking care not to move the RFCR. Alternate between

the two bolts several times, tightening each one until the two bolts are as

tight as possible.

Adjust the height and S-bend orientation

Loosen the Pinch Clamp on the ROP. Adjust the Vertical S-Bend tube to

correct height and orientation. Tighten the Pinch Clamp.

Caution:

The bolt on the Pinch Clamp should not be excessively tightened. The Pinch Clamp grips the Vertical S-Bend tube sufficient to prevent it rotating in the Index

Clamp or Removable Outer Piece when the Horizontal Tube is pushed firmly by a user. By design the Pinch Clamp does not provide an immoveable grip.

Extreme tightening of the Pinch Clamp bolt on the Vertical S-Bend tube in an attempt to prevent the Horizontal Tube from moving when very forcefully

pushed will crush the tube and jam the Pinch Clamp. DAESSY mounting assemblies are designed to carry the weight of a computer or communication

device and are not intended to resist a strong force exerted by the user.

Printed in Canada

the frame clamp on round tube. A larger gap indicates

the frame clamp may be too small for the tube. If there

is no gap and the inner piece does not clamp the

wheelchair tube firmly; up to 4 layers of aluminum foil

may be wrapped around the wheelchair tube, however

if more layers are needed it indicates the frame clamp

is too large. Contact Daedalus Technologies for

information on adapter sleeves.

Manufactured by Daedalus Technologies in Canada

Swing Aside Mount Assembly

www.daessy.com

DSAM4

Page 4 of 6