Canor TP106 VR Benutzerhandbuch - Seite 3

Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Verstärken Canor TP106 VR herunter. Canor TP106 VR 4 Seiten.

Switching on

If you have already connected all signal sources and speakers, connect the amplifier to the

mains. Please ensure the position of the volume control is fully counterclockwise (zero

volume).

Turn the amplifier on with the main Power Main switch, which is located at the rear panel.

When you turn on the switch, the amplifier is put into standby status - at the front panel the

red LED diode starts flashing. Pressing the Power button (at the front panel) initiates

controlled switching on sequence.

The first forty seconds the red LED diode blinks rapidly two times per second. Then the main

toroidal transformer gets connected (the CANOR logo lights up, and the volume control

backlights), and then begins the slow start-up of voltage provided by slow heating of vacuum

diodes.

During the second forty seconds the red LED diode blinks slowly once per second. During

flickering of the red LED diode the amplifier can be switched off only by the Main Power

switch at the rear of the panel, or by the Power button at the front panel - amplifier in this

mode can not be turned off by remote control.

After eighty seconds of turning on, the red LED diode goes out and the yellow LED diode of

the first input TUNER lights up– not untill that time the input signal using high-quality signal

relays gets connected. Then you can use the ⊳Input - Input

buttons to select an arbitrary

input.

Operate the input source and increase the volume control in a clockwise direction until an

audio signal is observed and you hear the sound from the speakers. If for any reason no output

is observed, please refer to the trouble-shooting guide.

When switching off by that Power button the amplifier only remembers the last selected input

and automatically re-selects after reclosure.

Trouble-shooting guide

The amplifier is completely broken: power cord is not properly connected to the mains.

Solution: connect the cable properly

No input signal to one or both channels:

Solution: select correct signal source using the input buttons

⊳Input - Input . Verify that the input signal cables are properly connected.

Verify that the output signal cables are properly connected to the speakers.

Lack of bass output, impossible stereo location

Solution: Check polarity of speaker connection

Caution! Inside your CANOR TP106 VR amplifier there are no parts or

adjusting features that user can set or correct