Cansec MAP1 Konfiguration - Seite 10

Blättern Sie online oder laden Sie pdf Konfiguration für Controller Cansec MAP1 herunter. Cansec MAP1 12 Seiten.

DhcpEnabled

Future

< USB INIT DONE >

9. Obtain all IP address information from IT personnel and modify the file accordingly.

Remove the line <USB INIT DONE> and save the file before removing it from your

computer.

10. Repeat from step 1 to step 6 then proceed to step 11.

11. Insert the flash drive into a USB port on a computer. When ready, launch Windows

Explorer or File Explorer. Access the USB drive and check if there is an error file

12. If no error file is present skip this step and proceed to step 13. Otherwise edit the error

file and review the errors indicated. Correct the errors in the MAPCFG.txt accordingly

and save it before removing it from the computer. Repeat step 1 to 6 then proceed to

step 11. See sample error file below.

blank

< USB INIT DONE > Please remove this line after this file

present along with the file

MAP1 IP Configuration

when the controller is disconnected

from the CloudACS server

DHCP is enabled by default

For future use only.

has been correctly modified. The

MAP1 controller reads parameters in

this file during boot up sequence and

configures the IP address accordingly

after which it will write <USB INIT

DONE> to indicate that the

initialization has been done.

July 2021 • Rev. 1.2

Page 10 of 12