Dot Origin VTAP100 Installationshandbuch - Seite 11
Blättern Sie online oder laden Sie pdf Installationshandbuch für Netzwerk-Hardware Dot Origin VTAP100 herunter. Dot Origin VTAP100 16 Seiten. Desktop usb reader
Auch für Dot Origin VTAP100: Installationshandbuch (13 seiten), Installationshandbuch (17 seiten)
Seite drucken2.3 Check status in BOOT.TXT
If you navigate to the VTAP100 in the computer's file system. It will appear as an attached
mass storage device and list the files contained, including the BOOT.TXT file.
Inspecting BOOT.TXT will give you essential information about your VTAP100 set up, at time
of last reboot, which might be helpful when troubleshooting.
You are most likely to need:
'ATCA' on VTAP100 - the serial number for your VTAP100.
l
'Firmware' - the VTAP100 firmware version in use.
l
'Hardware' - the VTAP100 hardware version in use.
l
'KeySlots used:' - a useful check that you have uploaded the necessary key files, since these
l
are deleted when they are uploaded. These two examples show how to read this
information:
'KeySlots used:------' shows that no keys have been uploaded.
o
'KeySlots used: 12--56' shows that key files 1 and 2 have been successfully uploaded, in
o
addition to the defaults 5 and 6.
'VCP enabled' - indicates that the virtual COM port has been enabled.
l
'Status' - should be 0 if operating normally, anything else indicates an error state.
l
'Boot time' - The time at boot, which defaults to 1970/00/00 00:00:00 if power is removed
l
to reboot.
If the configuration has been locked the BOOT.TXT file will end with the words LOCKED S/W
or LOCKED H/W.
VTAP100-USB INSTALLATION GUIDE
Figure 2-1 Example VTAP100 BOOT.TXT file
© DOT ORIGIN
VTAP MOBILE WALLET READERS
PAGE 7