DOTWORKZ COOLDOME ST-CD Installationshandbuch - Seite 4

Blättern Sie online oder laden Sie pdf Installationshandbuch für Kamera-Zubehör DOTWORKZ COOLDOME ST-CD herunter. DOTWORKZ COOLDOME ST-CD 17 Seiten. S-type cooldome enclosure

Seite drucken

Electrical Conduit Guidelines

For optimal performance, your Dotworkz Enclosure is designed to be Air & Water Tight to eliminate any

moisture, dust, and insect damage, safety, performance, reliability, and maintenance related issues.

Use of Electrical Conduit, without sealing the entry ports/ inside wire feeds within Camera Enclosure, will

subject the inside of your enclosure to possibility of condensation driven moisture, dust, and insect contamination

hazards.

enclosure to an IP68 rating, Waterproof and Airtight Seal. To properly seal, only one round cable is used in each

cable gland port. (

acknowledge this industry customization and installation practice, and would like to guide customers to properly

install these products.

Conduit Guidelines:

If wires, cabling, or conduit are coming at enclosure wire entry level, or above, always create a drip loop.

2) Please use only approved watertight electrical conduit and connectors, IP66 or better, with proper seals and fittings installed & fully seal.

3) Then, after all wire and cables are installed into enclosure, Seal wire entry ports inside of enclosure with any number of commercially

available sealing putty's, Silicone Sealant, or similar products that are approved by applicable local and relevant electrical codes.

FORCES AT WORK IN ANY UNSEALED, CONDUIT WIRE FEED ENCLOSURE SYSTEM

WARM/MOIST IN UNSEALED CONDUIT MOVES THRU CONDUIT

FEEDS EXPAND & CONTRACT WHEN CONDUIT HEATS & COOLS

WITH OUTSIDE TEMPERATURES

Humid Air

SHOCK HAZARD!

unsatisfactory product performance, a possibility of damage to electronics in the Dotworkz enclosure product,

including camera damage, and damage to integrated electronics due to air driven moisture traveling thru the

conduit, condensing and collecting in the enclosure creating a short circuit hazard.

Electrical Putty & Putty Tapes

Dotworkz does not endorse, nor has it evaluated any of these products. Test products first, and follow all manufacturers' instructions.

Follow all applicable electrical and building codes and installation guidelines. End user assumes liability for applicability of these products and

their effectiveness and incurred liability in using these products.

Dotworkz has provided each enclosure with two Cable Gland Strain Relief seal ports that fully seal

Holes on enclosure are 7/8" diameter, ready for standard ½" I.D. NPT connector, or PG13 fittings.)

However, we realize our customers are retrofitting these connectors with electrical conduit fittings. We

Dotworkz supplies two ½" diameter foam conduit plugs, that when installed, will assist in

sealing off airflow in conduit feed thru, at cable entry inside of enclosure. Putty or Sealant can be

used in conjunction with these plugs, to assure a full seal inside enclosure cable feed entry.

Failure to fully seal enclosure wire and cabling entry ports may lead to shock hazard,

EXPANDING HEATED AIR IS PUSHED INTO ENCLOSURE THEN COOLS &

CONDENSES, HUMID AIR CONDENSES ON SURFACES INSIDE

ENCLOSURE

Condensing to Water

Silicone Sealants

Foam Sealants (use very sparingly)