Double Horse 9116 Technisches Handbuch - Seite 2

Blättern Sie online oder laden Sie pdf Technisches Handbuch für Spielzeug Double Horse 9116 herunter. Double Horse 9116 8 Seiten.

DH9116 Transmitter - Signal Code Bind

To re-establish the signal link between the helicopter and the transmitter by gaining access to the transmitters

automatic signal code synchronization mode (transmitter bind).

Make sure you plug in the battery to the helicopter first, but leave the switch off, make sure you keep the heli

within very easy reach. Also, make sure the throttle stick trim is set all the way down.

Hold the transmitter in your left hand, and hold down the throttle stick in the throttle off position, as far down

as it can go with your thumb (without straining or breaking the stick).

With your other hand, switch on the transmitter, and then within the first 5 seconds, while the transmitter is

still flashing and beeping, quickly switch on the helicopter.

A red LED inside the canopy will also flash quickly.

After 15 seconds, the red LED on the transmitter will stop flashing and it will stop beeping. Check to see if the

red LED inside the helicopter's canopy has also stopped flashing and is now "solid" or not blinking, if so, the

helicopter is now bound to the transmitter and you should hear both servos 'flutter" as they settle into the

transmitters pre-set servo settings.

To double check to see if the helicopter is properly bound to the transmitter, hold the heli in the palm of your

hand at arm's length, and give the throttle stick a quick burst or throttle up, but still low enough so it doesn't

shoot up out of your hands and hit the ceiling. If the helicopter spins up, all is good. If not, you'll have to go

through the whole procedure again.