Electralog DF2006 Benutzerhandbuch - Seite 7
Blättern Sie online oder laden Sie pdf Benutzerhandbuch für Innenkamin Electralog DF2006 herunter. Electralog DF2006 15 Seiten.
Seite drucken6. Remove glass panel from styrofoam packaging.
7. Remove glass and fireplace from all packaging and plastic wrap.
FIGURE 2
FIrePlaCe asseMBlY
The only assembly required is to place the front glass assembly onto the
fireplace and install hardware to keep it in place.
1. With the fireplace laying on a flat and level surface from Step 4 of
the Unpacking Instructions, place the bottom of the glass panel onto
the glass support track located just in front of and below the ember
bed. (FIGURE 4A)
2. As shown in FIGURE 4B, lay the top of the glass panel into the
corresponding glass support track at the top of the viewable
fireplace.
Bottom of
Fireplace
FIGURE 4
3. Place glass retaining brackets as shown in FIGURE 5. The side of
the bracket which lines up with the 2 supplied screws should slide in
between the edge of the glass and the chassis. Refer to FIGURE 6
for an assembled view.
4. Using a flat head or Philips screwdriver, fasten screws through
chassis bracket and into glass retaining bracket.
5. Repeat for other upper corner.
www.sylvane.com 1-800-934-9194
A
Glass
FIGURE 3
B
End Cap
Top of
Fireplace
4