Doug Fleenor Design NODE2 Handbuch - Seite 3
Blättern Sie online oder laden Sie pdf Handbuch für Aufnahmegeräte Doug Fleenor Design NODE2 herunter. Doug Fleenor Design NODE2 10 Seiten. Two port ethernet to dmx512 interface
Seite drucken
Jumper settings
Five configuration jumpers are located on the rear of N
installation. Jumper functions are described in the table below.
Jumper
JP1
Front panel displays turn off after 30
seconds of inactivity
JP2
Port A up/down buttons operate normally
JP3
Port B up/down buttons operate normally
JP4
Normal operation
JP5
Normal operation
Jumper settings are only read during power up. If a jumper position is changed, power must
be cycled for the change to take effect.
Mounting
N
2 can be mounted in many standard two-gang electrical boxes. A deep box (minimum
ODE
2.125 inches) is required for the electronics and to allow space for the network connection.
Raco model 683SP is an example of such a box.
Care must be taken to ensure that no part of the electronics are touching the box. Do NOT
attempt to install N
ODE
box will destroy a powered unit.
Powering
N
2 is powered using Power Over Ethernet (PoE). This simplifies installation by allowing the
ODE
installer to pull a single CAT5 (or higher) cable to N
Ethernet signals. A PoE switch or a PoE power injector must be used to provide power to
N
2. The diagrams below illustrate both methods of powering N
ODE
PoE Switch
PoE Injector
Installed function
2 while power is applied as even momentary electrical contact with the
Page 3 of 10
2. Jumpers should be set prior to
ODE
Removed function
Front panel displays are always on
Port A buttons are locked out
Port B buttons are locked out
Restore factory default settings
Force into boot loader mode
2. The cable provides power and
ODE
2.
ODE